Panasonic DIGA DMR-E75V Operating Instructions Manual

Also see for Diga DMR-E75V: Operating instructions

Contents

Playback52It is also possible to play back tapes recorded in the S-VHS system.≥Some picture noise may occur depending on the type of tape used.≥It is not possible to fully obtain the high resolution that S-VHS iscapable of.≥It is not possible to record in the S-VHS system with this unit.During play or while stoppedKeep pressing [1, PLAY] for 5 or moreseconds.≥The “RP” indication appears on the display.∫ To cancel the Recorded Part RepeatedlyPress [∫, STOP].This unit automatically records special index signals on the tapeevery time a recording is started. The Index search function makesuse of these index signals to let you find the beginning of a desiredprogramme quickly and easily.While stopped or during normal playPress [:] or [9].≥The unit automatically starts playback after theindex signal is found.≥Each press increases the number of skip.∫ To cancel the Index Search or to stop playbackPress [∫, STOP].Note≥Up to 20 index signals can be searched for in both directions.≥When you press either one of the button too much, you can controlthe number of skips by pressing the opposite button.≥The figure on the display decreases by 1 each time an index signalis located.≥This feature may not work correctly if the marks are too closetogether. Make recordings of at least 5 minutes.The unit automatically makes tracking adjustments, but you mayneed to do it manually, if noise appears on a tape recorded on otherequipment.During normal or slow playback,Press [TRACKING/V-LOCK, i, j] until the barsnoise disappear.≥If the noise bars appear during still playback, switch the VHS overto the slow playback mode and then adjust the tracking.∫To return to auto trackingPress both [TRACKING/V-LOCK, i, j] i and j simultaneously.If the still picture shakes, perform the following operation.During still playback,Keep [TRACKING/V-LOCK, i, j] pressed until thepicture stops shaking.∫To return to auto trackingPress both [TRACKING/V-LOCK, i, j] i and j simultaneously.∫To remove the noise from a paused pictureStart slow play, then adjust the tracking.Note≥This may not work with some TV models and tapes.You can play back a tape in Progressive video or RGB video with TPchannel.PreparationConnect this unit and the TV and then set the output.≥RGB Output l 9, 45≥Progressive l 14, 45[1] Press [DVD].[2] Press [CH, W, X] to select the “TP” channel.≥About TP channel l 59[3] Press [VHS] and then press [1, PLAY].≥The tape starts playing back in high picture quality.Note≥Check if the setting on “TV Aspect” is suited to the size of your TV.(“SETUP”-“Connection”-“TV Aspect”, l 45)≥The TV must be RGB-compliant or Progressive-compliant.Preparation≥Press [VHS].≥Insert a recorded video cassette.S-VHS Quasi Playback (SQPB)To Play back a Recorded Part RepeatedlyVHS Index Search System (VISS)SLOW/SEARCHREW FFDUBBINGDVD/VHSCREATECHAPTERSKIP/INDEXPLAYSTOP PAUSETRACKING/V-LOCKAUDIOEXT LINKFUNCTIONSDIRECT NAVIGATORTOP MENURETURNSUB MENUPROG/CHECKVHS RECTIME SLIPSTATUSDVD RECREC MODEDVD/VHSCANCEL/RESET INPUT SELECTDIRECT TV RECTIMERVHSVHSG-CodeCREATECHAPTERCHAVVOLUMEDVDDVDJET REWENTERDISPLAYTRACKING/V-LOCK, i, jCH, W, XSTATUS1;∫:, 9ENTERμDVDREC MODEEXT LINKVHSNumericButtons Adjusting the playback picture∫ Manual tracking∫ Vertical locking adjustmentTo Play back a tape in high picture qualityVHS