Menu
Panasonic CZ-256ESMC2 Operation Manual
Also see for CZ-256ESMC2: Operation manualOperation manual
                                                            | |
Contents
|
3-142Control of 2WAY SYSTEM1234567898. Intelligent Controller (CZ-256ESMC2)246 Using the System6.3.3 Setting central addresses, unit names and tenant numbersUse this screen to set central addresses, names of units connected to the system and tenantnumbers.ProcedureSelect 5.Initial settings in the main menu and 2.CNTR/Unit/Ten. No. in the sub menu, thenproceed as follows.21 31.Status/Control2.Total data/Cut-off3.Distrib. ratio/Usage4.Maintenance/Test Run5.Initial settings6.Auxiliary settings1.Date/Distrib.2.CNTR/Unit/Ten. No.3.Ten. name/Distrib. Gr.4.Pulse meter setting5.Clear accum. data1 When you touch a central address column, a screen will be displayed as shown on the right.Input a number 1 to 64 to set central address.When you touch [Auto], the central address will be automatically set.Two identical central address settings cannot be used within a link system. If you input an existingaddress, the input data is cancelled.It may take several minutes before the central address settings are reÀected in the display.When other central controllers (system controller, etc.) are connected, it is recommended to set thecentral addresses on those units.Main Sub2255256 Using the System2 Touch an unit name column. A keyboard window like the one shown below appears.Use the keyboard to enter an unit name. Unit names can be up to 12 characters long.* See “7 Entering Text and Numbers” for details about entering text in keyboard windows.* You can copy and paste text using the [Copy] and [Paste] buttons. See “7.2 Entering Text” for details.3 Touch a tenant number.A keyboard window like the one shown below appears. Use thekeyboard to enter the tenant number.* The tenant number range is from 1 to 256.Main Sub2255 |
Related manuals for Panasonic CZ-256ESMC2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved