Panasonic CT-27HL15 Manual

Also see for CT-27HC15: Operating instructions

Contents

Panasonic CT-27HL15 Manual Manual pdf 6 page image

INSTALLA ]'IONInstallationTelevision LocationThis unit is intended to be used with an optional stand orentertainment center. Consult your dealer for availableoptions.• Avoid excessive sunlight or bright lights, includingreflections.• Keep away from excessive heat or moisture. Inadequateventilation may cause internal component failure.• Fluorescent lighting may reduce remote controltransmitting range.• Keep away from magnetic equipment, including motors,fans and external speakers.WARNING: Use this television receiver only with thecart, stand, tripod, bracket, or table specified by themanufacturer, or sold with the apparatus. When a cartis used, use caution when moving the cart/apparatuscombination to avoid injury from tip-over. In order toavoid injury to children, never place your television receiver on apiece of furniture that is capable of being tilted by a child leaningon it, pulling on it, standing on it, or climbing on it. A fallingtelevision can cause serious injury or even death.CT-32HC15, CT-32HC15U:CAUTION: These television receivers for use only withPANASONIC TY-32SC15T stand. Use with other carts(or stands) is capable of resulting in instability causingpossible injury.CT-32HL15, CT-32HL15U:CAUTION: These television receivers for use only withPANASONIC TY-32HL15T stand. Use with other carts(or stands) is capable of resulting in instability causingpossible injury.Optional Cable ConnectionsShielded audio and video cables should be used betweencomponents. For best results:• Use 75-ohm coaxial shielded cables.• Use appropriate input and output connectors, that matchyour component connectors.• Avoid long cables to minimize interference.AC Power Supply CordCAUT,O.:TOPREVENTELECTR.CSHOCK,MATCH WIDE BLADE OF PLUG TO WIDE SLOTOF AC OUTLET AND FULLY INSERT. DO NOT PolarizedplugUSE A PLUG WITH A RECEPTACLE OR OTHEROUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TOPREVENT BLADE EXPOSURE.PROTECT POWER CORDS FROM BEING WALKED ON, ROLLEDOVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXITFROM THE APPARATUS,Cable / Antenna ConnectionFor proper reception, either a cable or antenna connectionis required.Cable ConnectionConnect the cable supplied by your localcable company. Tighten with fingers only.Use of any tool (e.g. pliers) for tighteningmay result in tuner damage.Note: A cable converter box may berequired for proper reception.Check with your local cablecompany for compatibility requirements,Incoming Cable fromCable Company75 Ohm VHF/UHFon back of TVAntenna ConnectionNote:• Connect home antenna toANT connection on back oftelevision. Select TV mode inthe SET UP menu.Cable Mode is preset at thefactory. Antenna users mustchange to TV Mode in the SetUp menu (page 15).For proper reception of VHF/UHF channels, anexternal antenna is required. For best reception anoutdoor antenna is recommended.Incoming Cable fromHome AntennaRemote Control Battery InstallationRequires two AA batteries (supplied).Battery Polarity®®Procedure1. Turn the remote control face down. Remove batterycover by pressing down on the marking on the coverand sliding it off in the direction indicated.2. Install batteries matching (+) and (-) polarity signs.3. Replace the battery cover by sliding in reverse until thelock snaps.Note: Incorrect installation can cause battery leakage andcorrosion that will damage the Remote Control.Precautions• Replace batteries in pairs.• Do not mix battery types (zinc carbon with alkaline).• Do not recharge, heat, short-circuit, disassemble, orburn batteries.40