Panasonic CQ-DVR909N Operating Instructions Manual

Contents

ENGLISH5ENGLISH6CQ DVR909N CQ DVR909N26 27Setting Up the SpeakersSetting Up the Speakers (continued)(continued) Indicates pressing a button. Indicates pressing a buttonfor an extended period of time.F / RMUTESUB TITLEAUDIOANGLEREPEATSTOP PAUSE PLAYBANDRANDOMSCANC.SPCLOCKST/MONOTITLE /CHAPTERPAGETRACK1470VOLUMEMENUTITLERETURNCAR DVD PLAYERSOURCEPOWERSEL985623DISPGRPSelect the settingmenu1 Switch to setting mode.2 Select the setting menu.Notes:≥ Press [DISP] to complete the settingprocedure. (The unit returns to regular mode.)≥ The unit completes the setting procedure ifno buttons are pressed for 10 seconds.(The unit returns to regular mode.) (Whenadjusting the speaker output level, the unitwill wait 18 seconds.)Make settings1 Select a speaker.2 Set the speaker.≥ Repeat items 1 and 2 for all speakers.≥ The icon corresponding to the speakertype, which is currently being set, blinks.122;; 1 2 DISCX WX WP•SET1212S•MODESOUND•MODES•MODESOUND•MODE(á page 59)(Dolby Digital encoded material only)(While stopped)[Dolby Digital encoded material or when“PROLOGIC ON” (á page 51) is set only](*Dynamic Range Compression)(á Next page)(á Next page)(á Next page)SP DELAYSP LEVEL SELSP TYPE SELDR COMP SEL *FM1 102.50 (Regular mode)When using the main unitDISP(DISPLAY)C.SP(CENTER SPEAKER)POWERSOURCEVOLUME"#TUNETRACKX W6 5Preparation:≥ Turn on the power. (Main unit: )≥ Open the center speaker. (Main unit: )When you adjust the speaker output levels, switch to the disc mode and operate while stopped. (á pages 38, 40)POWERSOURCEPressPressSOURCEPOWERSPEAKEROPEN/CLOSEC.SP7POWERSOURCESPEAKER OPEN/CLOSE !Set Each Speaker Type and whether They are Present or NotLARGE : Large speaker. When bass playback is possible. (100 Hz or lower is the target.)SMALL : Small speaker. When bass playback is not possible.NONE : When not using a center speaker that was purchased separately.YES : When using a subwoofer.NO : When not using a subwoofer.Note:≥ If “SMALL” or “LARGE” is set for “OPT•C” (the optional center speaker), the attached centerspeaker of this unit is not operated. Otherwise, “NONE” should be set.SP TYPESELAdjust the Speaker Output LevelsUsing a test signal, adjust the audio output of each speaker so that the volume levelfrom every speaker sounds equal. (Adjustable range: 0 to `12 dB)Adjust the Speaker Delay TimesSet a delay for the output from center and surround speakers so that the sound from theother speakers reaches the listening position at the same time as the front speakers.(Adjustable ranges: Center speaker 0 to _4 ms Surround speaker 0 to _15 ms)SP LEVELSELSP DELAYThe test tone sounds for 2 seconds at each speaker in the following sequence:1 2To adjust the test signalvolume:VOLUME["]: Increases level.[#]: Decreases level.1 2 ["]: Increases delay.[#]: Decreases delay.Note:≥ The test signal is not output from a speaker for which “`¶” was set. (á page 53)Note:≥ The center speaker can be adjusted only while playing back Dolby Digital encoded material.CENTER : 0 ms SUR : 0 msSUB•WFR : YESSUB•WFR : NOOPT•C NONE SUR : LARGESUR : SMALLOPT•C SMALLOPT•C LARGEFRONT : SMALL(Center speaker, sold separately)FRONT : LARGE2 222 2 2111 1(Front speaker) (Surround speaker) (Subwoofer)L(left front)RS (right surround)LS(left surround)SW(subwoofer)C(center) (right front)RFRONT•L 0 dBL•SUR 0 dBSUB•W 0 dB R•SUR 0 dBCENTER 0 dB FRONT•R 0 dBPressHold (2 seconds)PressPressPress

/ 14

Related manuals for Panasonic CQ-DVR909N