Panasonic CQ-C7300N Operating Instructions Manual

Contents

Panasonic CQ-C7300N Operating Instructions Manual Manual pdf 5 page image

PreparationEnglish98weqq Pull out the batterycase while pushing thetab.w Put a battery in thecase with (+)-side fac-ing up.e Put the case back.Battery Notes¡Remove and dispose of an old battery immediately.¡Battery Information:Battery Type: Panasonic lithium battery (CR2025)(Included)Battery Life: Approximately 6 months under normaluse (at room temperature)¡ Do not disassemble or short the battery. Do not throwa battery into a fire.¡ Keep batteries away from children to avoid the risk ofaccidents.¡ Follow local regulations when disposing of batteries.OFFACCIGNFor a ACC-equipped car, select ON. (a Page 17) Thefollowing functions are available. (default: off)¡ The power is turned on automatically when insertinga disc or magazine.¡ The clock can be displayed even if the power is off.(a Page 13)¡ After the security function (a Page 17) is set to ON,the function works when turning the ignition key toOFF.¡ The unit can be activated just at the push of a button.: ACC not equipped(Default): ACC equippedCaution: Improper use of batteries may causeoverheating, an explosion or ignition, resulting ininjury or a fire.Caution:Be sure to select OFF when your car has noACC position in the ignition switch. Failureto do this could cause the battery to godead.Notes:¡ Adjust the clock when “NO CT” appears on the dis-play.¡ When a broadcast of FM Radio Data System isreceived, the clock is put right automatically by theClock Time service. (a Page 20)1 Select the radio AM mode. (a Page 18)2 Press and hold [DISP] (Display) formore than 2 seconds.3 Press []] or [[] to adjust the hour.[[]: Forward[]]: BackPress [DISP] (Display) to confirm theadjustment.4 Press []] or [[] to adjust the minute.[[]: Forward[]]: BackPress [DISP] (Display) to confirm theadjustment.The demonstration message appears for first use.1 Press [SOURCE] (PWR: Power).The demonstration screen appears.2 Press [DISP] (Display).The demonstration screen is cancelled, and no moreappears.Note: If you would like to turn on the power and makethe demonstration message appear, hold down[SOURCE] (PWR: Power) for 4 sec. or more. (at ACCon) You may need to set the following depending on thedevices to be connected.Using Subwoofer¡ Subwoofer level adjustment (a Page 15)¡ Subwoofer low pass filter (a Page 15)¡ High pass filter (a Page 15)The following functions are activated when the SecurityFunction is ON. (a Page 17)¡ The security indicator lights up when removing theface plate.¡ The alarm sounds and the message appears on thescreen to warn you to remove the face plate at poweroff.Note: After the ACC setting is set to on, these functionswork when turning the main power off. (a Page 17)Security IndicatorCQ-C7300NBANDPreparationBattery into Remote ControlACC SettingClock adjustmentFirst Time Power On(DEMONSTRATION)Other Settings Security Function Setting