Panasonic CQ-C7300N Operating Instructions Manual

Contents

Panasonic CQ-C7300N Operating Instructions Manual Manual pdf 10 page image

19 EnglishRadioUp to 6 stations can be preset in AM (MW/LW), FM1,FM2, and FM3 respectively.Preset stations can be simply called up by pressing [}](P·SET) or [{] (P·SET).Note: Direct selection can be executed with [1] to [6]buttons on remote control.Auto Preset Memory (APM)1 Select a band.2 Hold down [BAND] (APM)for 2 sec. ormore.Up to 6 best receiving stations are preset.The preset stations under best receiving conditionsare received for 5 sec. each after presetting the sta-tions (SCAN). To stop scanning, press [}] or [{].Notes:¡ New stations overwrite existing saved stations.¡ Only RDS stations will be saved at default setting (AFON). To select non RDS stations too, set AF OFF. (aPage 21)Manual station preset1 Tune in to a station.2 Hold down [}] or [{] for 2 sec. ormore.3 Select a preset number by pressing [}]or [{].4 Preset the station by holding down [}]or [{] for 2 sec. or more.Frequency/preset number blinks once.Notes:¡ New stations overwrite existing saved stations.¡ In step 2, a station can be registered by holding downthe numeric button [1] to [6] for 2 sec. or more.¡ To stop presetting stations, press [DISP] (Display).CQ-C7300NBANDNote: In AM mode, only LOCAL can be selected.1 Press [MENU] to open the menu.(a page 16)For using the remote control, hold down [MENU]for 2 sec. or more.2 Press [MENU] to select a mode to beadjusted.The selection/adjustment screen appears 1 sec. aftermode selection.3 Press [BAND] (SET) to adjust the set-ting value.4 Press [DISP] to return to the regularmode.Note: If no operation takes place for more than 10 sec-onds, the display returns to Regular Mode.FM MONO (Monaural)Noise reduction when the receiving sensitivity becomeslowReceiving in stereo (Default)Receiving in mono and reducing the noise level( lights.)FM LOCAL/AM LOCALSetting when searching for a stationSearching even for a relatively low-intensity radiowave station (Default)Searching only for a high-intensity radio wave station( lights.)Often-tuned Station Preset(APM: Auto Preset Memory, P·SET: Preset)Radio Menu DisplayMONO/LOCAL18Radio1 Press [SOURCE] to select the radiomode.2 Press [BAND] to select a band.Notes:¡ For tuning in on only stations whose receivingconditions are good in the station search, setLOCAL to ON. (a page 19)¡ For reducing noise when a receiving FM stereowave is weak, set FM MONO to ON. (a page 19)3 Select a station.Frequency adjustment[]] (TUNE): Lower[[] (TUNE): HigherNote: Hold down for 0.5 sec. or more and releasefor station search.Preset station selection[{] (P·SET: Preset): Lower preset number[}] (P·SET: Preset): Higher preset numberNote: Direct selection can be executed with [1] to[6] buttons on remote control.CQ-C7300NBANDPreset NumberBand FrequencyLOCAL IndicatorST (Stereo)IndicatorDisplay changePress [DISP] (Display) to change.CT Clock TimeNormalDisplay offFrequencyPSCTDisplay offAM (MW/LW) mode:FM (not RDS) mode:This chapter explains how to listen to the radio.Operation FlowRadio Mode Display