mn=zi)CG=82b ! N a Vv iInstallation GuidePreparation® Disconnect the lead from the negative (—) battery terminal (see caution below).Caution: Do not disconnect the battery terminals of a car with trip or navigational computer since all usersettings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.Dashboard InstallationInstallation Opening ) AThe unit can be installed in any dashboard having anopening as shown on the right. The dashboard should 7be 4.5 mm - 6 mm thick in order to be able to supportthe unit bn ~182 mm—Installation PrecautionsIf possible, have the equipment installed by a professional installer.If you should encounter any difficulties, please consult your nearest authorized Panasonic Service Center.1. This unit is designed exclusively for use in cars having a 12-volt negative ground battery system.2. Follow the instructions for electrical connection carefully. Failure to do so may result in damage to theunit.3. Connect the power cord after all other connections are made.4. Be sure to connect the YELLOW lead to the positive (+) terminal of the battery or to the fuse block (BAT) terminal5. Insulate all exposed wires to prevent short circuiting.6. Secure all loose wires after installing the unit.7. Carefully read the operating and installation instructions of the respective equipment before connectingit to the unit.Supplied Hardware aNo.| Item |Diagram |Q'ty | | No.| Item Diagram |Q'typd |nn‘ ERAGURE i | i 1, Remote controlholder -9| 4a lounting collar \ x | ‘1 \ (with Double-Sided Tape! an|~~ | |! ( pe) S&S7)(2) Rear support strap | z 1 13, Remote control unit 1&va) | Tapping screws 7 a4 i3 (5 mmo x 16 mm) | ? 4 14 | Batteries (R6PU) 2Tapping screws with Washers@) simmax 6 mm) | ¥ 4 15 |Trim plate 1(5) Mounting bolt (5 mmo) | ay 1 |t | = 16 Mounting plates ! 2(6) Hex. nut (5 mmo) ® 1 L- |Tapping screws (5 mm) SP 2 a” _L-Shaped brackets _ 2Infrared receiver 1 |‘8° (with Double-Sided Tape) 18 Clip connector 4(9: Speed Plus Cord (5 m) 1 19 Protective Sheet CS 1|‘20 L-shaped Bracket } 4(0 | GPS antenna 1 \ |it | oy Cord Clamp Qe | :| a) |Power connector 1 2 (including Double-Sided Tape) Zo ||