Panasonic CN-DV2000EN Operating Instructions Manual

HSITDNA76The vehicle position is notcorrectly shown while trav-eling.|| GPS signals cannot beGPS symbol is not dis-played.Distance compensation isincomplete.Vehicle speed pulses arenot correctly connected.received due to an obsta-cle.GPS antenna cable con-| nection is incomplete.Your car location is notshown.No voice guideRemote control buttons donot beep,Map is not displayed(Screen blank)The system is in mapmode.Voice guide volume is setto zero.The vehicle is off the route.The vehicle is going back-wards on the route.Beep is set to OFF.Beep was set improperlyduring monitor setup.Map disc is wet due to con-densation, scratches, ordirts.Turn the beep on.Check if distance compen-sation has been completed.(See page 86.)Read the manual andcheck the connection.GPS signals will bereceived when there arenot any more obstacles.Check GPS antenna con-nection with the installationcheck screen. (If the cableis unconnected, read themanual and check the con-nection.)Press the button.Raise the voice guide vol-ume.Check the route guide dis-play on the current positionmap. Repeat route search.Check the direction for yourdestination.Repeat route search.Set the monitor appropri-ately for the type of monitorconnected.Check if the map disc iswet due to condensation,scratches, or dirts.