14TouchscreenThe touchscreen function can not be used in the MS-DOS mode and when usingthe full screen in [Command Prompt].Handling the TouchscreenUse the stylus included with the wireless display. Do not use an implement otherthan the stylus that comes with the wireless display.Do not place any object on the surface or press down forcefully with sharp-pointedobjects (e.g., nails), or hard objects that can leave marks (e.g., pencils and ballpoint pens).Do not operate the wireless display when such things as dust are on the screen. Donot allow substances such as oil to contact the LCD. The cursor may not workproperly in such cases.When the touchscreen becomes dirty:Wipe lightly to remove dirty areas by using a dry soft cloth (included).Do not use benzene or thinner, or disinfectant-type alcohol.(For more information, refer to “Suggestions About Cleaning the LCD Surface”that comes with the soft cloth.)Handling the StylusClean the stylus tip and screen prior to operation. Foreign particles can scratch thescreen and impede the operation of the stylus.Use the accessory stylus only on the wireless display screen. Using it for any otherpurpose may damage the stylus and scratch the screen.Do not use pencils, implements with sharp tips or hard objects for screen opera-tions. The screen may be damaged as a result.CAUTIONRight-ClickingPress R-button.1 2When “R” isdisplayed ont h e r i g h t -lower cornerRR-ButtonOne tapNOTEIf the R-button is pressed again when setting right-clicking function to enable,the right-clicking function will be set to disable.