Panasonic CF-37 Series Reference Manual

Also see for CF-37 Series: Operating instructions Supplementary instructions Supplementary instructions Reference manual Reference manual

Panasonic CF-37 Series Reference Manual Manual pdf 62 page image

62Dealing with Problems (Advanced)When a problem occurs, refer to this page. If you still cannot troubleshoot the problem, contact Panasonic TechnicalSupport.Starting UpThe power indicator orbattery indicator is not litis displayed[POST Startup Error(s)]is displayedWindows startup, or anoperation is extremelyslowThe date and time areincorrectWhen the previous itemis not the causeWindows NTNT does not start upWindows 2000When resuming from thestandby or hibernationmode, does not appeareven if a password has beenset in the Setup UtilityCheck the cable connection for the AC adaptor.Check to see if a fully charged battery is properly installed.Remove the battery pack and disconnect the AC adaptor, then connect them again.Input your password. If you have forgotten it, contact Panasonic Technical Support.page 60Press F9 in the Setup Utility ( page 51). This will restore the Setup Utility'ssettings to their default values (except the password settings). Then, the Setup Utilitymust be run once again for you to input the appropriate operating environment settings.(The processing speed depends on the application software used, so this operation maynot cause the processing speed to increase.)You can set the date and time through [Date/Time] in [Start] - [Settings] - [Control Panel].When the computer is connected to a Local Area Network (LAN), confirm the dateand time of the server.If you continue to experience problems, the internal battery maintaining the clockmay need to be replaced. Contact Panasonic Technical Support.This computer will not correctly recognize the date and time starting from the year2100 A.D.Windows NTWhen [APM 2.0 for NT] is not displayed in [Control Panel], this indicates that PhoenixAPM 2.0 for Windows NT ® is not installed. When the standby or hibernation functionis used under this condition, the date and time may be incorrectly displayed. Correctthe date and time, and then install Phoenix APM 2.0 for Windows NT® .When the standby or hibernation function is used frequently, discrepancies mayoccur in the display of the date and time even if APM 2.0 for Windows NT is in-stalled. You can set the date and time through [Date/Time] in [Start] - [Settings] -[Control Panel].Press F9 in the Setup Utility ( page 51). This will restore the Setup Utility'ssettings to their default values (except the password settings).Try removing all peripheral devices.Windows 2000Click [Local Disk(C:)] in [My Computer] with the right button, select [Properties],and then select [Tools] - [Check Now].At start-up, press F8 to operate the computer in the Safe mode.If [Cancel] at the [Path not found] is clicked during the LAN card driver installation, thenext time the system is activated it will hang up without NT being activated.In such cases, follow the steps listed below.1 Power off, then power on again.2 If [Press spacebar NOW to ...] is displayed, press the space key.3 If [Hardware Profile/Configuration Recover Menu] is displayed, press L , thenpress Enter .4 At the [PCMCIA Card Not Configured], select [OK].5 At the [Path not found], put the disk that was supplied with the LAN card into thedisk drive, then select [OK].Follow the on-screen instructions.Use the Windows password as the following.Select [Start] - [Settings] - [Control Panel] - [Power Options] - [Advanced], then addthe check mark for [Prompt for password when computer goes off standby].