Panasonic CF-37 Series Reference Manual

Also see for CF-37 Series: Operating instructions Supplementary instructions Supplementary instructions Reference manual Reference manual

Panasonic CF-37 Series Reference Manual Manual pdf 61 page image

61List of Error Codes02F5: DMA Test FailedServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.02F6: Software NMI FailedServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).02F7: Fail - Safe Timer NMI FailedServerBIOS2 test error: Fail-Safe Timer takes too long.device address ConflictAddress conflict for specified device.Allocation Error for: deviceRun ISA or EISA Configuration Utility to resolve resource conflict for the specified device.Failing Bits : nnnnThe hex number nnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in themap indicates a failed bit. See error 230,231 or 232 for offset address of the failure in System, Extended orShadow memory.Invalid System Configuration DataProblem with NVRAM (CMOS) data.I/O device IRQ conflictI/O device IRQ conflict error.Operating System not foundOperating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: areproperly identified.Parity Check 1 nnnnParity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannotlocate the address, it displays ????. Parity is a method for checking errors in binary data. A parity error indicatesthat some data has been corrupted.Parity Check 2 nnnnParity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannotlocate the address, it displays ????.Press to resume, to SetupDisplayed after any recoverable error message. Press to start the boot process or to enter a Setup andchange the settings. Write down and follow the information shown on the screen.