47LANEnabling the Power On by LAN functionThe computer automatically turns from off to on when the computer is accessed from the network server via the internal LANport.1 Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility (Î page65).2 In [Caution], press Enter.3 Press F10, and then select [Yes] and press Enter.4 Log on to Windows as an administrator.5 Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -[Device Manager] - [Network adapters] and double-click [Marvell Yukon 88E8055 PCI-EGigabit Ethernet Controller], and then click [Advanced].6 Click [Wake From Shutdown] in [Property] and select [On] in [Value], and then click [OK].NOTEz The computer may accidentally turn on if the linkage status is changed. To prevent the accidental startup, make thesetting by the following steps.A Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [Net-work adapters] and double-click [Marvell Yukon 88E8055 PCI-E Gigabit Ethernet Controller], and then click[Advanced].B Click [Wake Up Capabilities] in [Property] and select [Magic Pocket] in [Value], and then click [OK].Enabling/Disabling the Wake Up from wired LAN functionWhen the Wake Up from wired LAN function is enabled, the computer automatically resumes from standby or hibernationwhen the computer is accessed from the network server via the internal LAN port. (Default setting)The Wake Up from wired LAN function can be switched to enable/disable by performing the following procedure.1 Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -[Device Manager] - [Network adapters] and double-click [Marvell Yukon 88E8055 PCI-EGigabit Ethernet Controller], and then click [Power Management].