Panasonic CF-30 Series Reference Manual

Also see for CF-30 Series: Supplementary guide Supplementary instructions Supplementary guide Supplementary instructions Supplementary instructions

Panasonic CF-30 Series Reference Manual Manual pdf 39 page image

39External DisplayYou can switch the output destination to an external display.Connect the external display to the external display port (A).NOTEz After resuming from hibernation or restarting the computer, the output destination may not be the same as the selectedin the previous status.z When you change the display after Windows starts up, do not press any key until switching is complete.z Display switching by pressing Fn+F3 may not work when you use the Fast User Switching function to switch the user.In this case, log off all users and restart the computer.z Display switching does not work when [Command Prompt] screen is set to “Full Screen”.z When you use the external display only, set the suitable number of colors, resolution, or refresh rate separately fromwhen you use the internal LCD only or when you use the simultaneous display.Depending on the settings, some external displays may be distorted or may not display the mouse cursor correctly. Inthis case, set the settings to lower value.z When you use the simultaneous display, DVD-Video, MPEG files and other motion image files may not be played backsmoothly.z Carefully read the instruction manual of the external display.z When connecting an external display that does not conform to the Plug & Play standards, select the display driveraccordingly in the following menu, or use the driver disk supplied with the monitor.[start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced] - [Monitor] - [Properties] -[Driver] - [Update Driver]z If a picture is not displayed normally, lower the level of [Hardware acceleration] in the following menu.[start] - [Control Panel] - [Appearance and Themes] - [Display] - [Settings] - [Advanced] - [Troubleshoot]CAUTIONz Before disconnecting the external display, switch to the internal LCD by pressing Fn+F3. Otherwise the displayedimage quality may become different after disconnection (e.g., wrong resolution). In this case, press Fn+F3 to resetthe image quality.z The screen may become distorted due to the following operations. In this case, restart the computer.• Disconnecting an external display for which you have set high resolution or high refresh rate.• Connecting/disconnecting an external display during computer operations.