iPod with video controlControllable iPod with video/software versionConnecting a video-output-ready iPod (5th generation,version 1.2) to navigation unit via the Direct Cable foriPod with video (CA-VDC300U, option) allows users toenjoy playing moving pictures or sounds downloadedto the iPod with use of iTunes.This section describes only video output and its relatedtopics about the 5th generation iPod with video outputfunction (version 1.2). Refer to the System UpgradeGuidebook for other operations at an iPod connected.* Operation has been confirmed for software availableat the end of June, 2007. We do not guarantee properoperation with our future products or upgraded software.Note: Perform the video playback operation on the iPodwith video device. Moving pictures downloaded with iTunes areexclusively playable on navigation unit. Movingpictures using Mass Storage Class are not supported. It may take time for the navigation unit to change thesource to the iPod after iPod connection. On the one hand, if the iPod is connected duringaudio fi le playback, the navigation unit plays from theongoing portion. On the other hand, during video trackplayback, the navigation unit plays from the beginningof all the fi les. The number of displayable characters for a fi le nameis limited. (up to 252 bytes) Switching from the audio display to the video displayand the audio display again provides playback fromthe beginning of the current fi le. By upgrading the software version, iPod and iPod withvideo volumes are stored separately.Preparation: Connect an iPod with video with the Direct cablefor iPod with video (CA-VDC300U, option).Video from the iPod with video is not displayedwhile the vehicle is in motion.Stop in a safe place and engage the parking brakebefore watching video.English2626