Panasonic BT-S950 Operating Instructions Manual

Contents

Panasonic BT-S950 Operating Instructions Manual Manual pdf 7 page image

722232524OUTINOUTINS-VIDEOAFCNORMALFASTOUTINSERVICECUT OFFB1RGDRIVERGVIDEO AOUTINEXT SYNCAUDIOTALLY/REMOTEOUTINVIDEO BAC INDC IN12V221THIS APPARATUSMUST BE EARTHED+-LINE BLINE AWARNING< Rear Panel >21OUTINAFCNORMALFASTTALLY/REMOTETo AC outlet(120 V AC, 50 Hz/60 Hz)21 TALLY/REMOTE terminalExternal control terminal (DIN 8-pin). Tally lamp, VIDEOA/B (input selection), Under Scan, External Sync, 4:3/16:9(aspect ratio), Pulse Cross, and Color Off modes can becontrolled from an external unit.Note:* When you’re controlling the monitor externally via theTALLY/REMOTE terminal, set all correspondingswitches on the front panel to the OFF (G) position.(Whichever switch is pressed first has priority so remoteswitches may not function if the panel switches are ON(g) position.) TALLY/REMOTE terminal pin layoutPin No. Signal1 TALLY lamp ON/OFF2 LINE A/B A/B(Input Select)3 UNDER SCAN ON/OFF4 EXT SYNC ON/OFF(External Sync)5 4 : 3 /16 : 9 4 : 3 /16 : 9(Aspect Ratio)6 PULSE CROSS ON/OFF7 MONO(color off) ON/OFF8 GND22 Power input connectorSupply power to either the AC IN or DC IN 12 Vconnector.[AC IN]Connect the provided AC power cord between the AC INconnector and an AC outlet (120 V AC, 50 Hz/60 Hz).[DC IN 12 V]Connect the 12 V DC power plug to the DC IN 12 Vconnector.Notes:* See your dealer for more information on 12 V DC powersupply.* When both AC IN and DC IN connectors are used, theAC input has priority.* The DC power supply does not automatically take overif an AC outlet is unplugged or the AC power is cut offwhen both AC and DC power supplies are connected.In this case, press the POWER switch to set to OFF,then press it again to turn the power ON. DC IN 12 V connector pin layout23 Power cordConnect the provided power cord (120 V AC, 50 Hz/60 Hz)to the AC IN connector.24 External battery mounting holesAttach an external battery to either pair of holes (1 or 2) touse 12 V DC power (depending on the type of battery).Notes:* External batteries manufactured by Anton Bauer or PAGare available.* See your dealer for details.25 Switch/control adjustment holes for servicepersonnelFor adjustment of SERVICE switch, CUT OFF (B, R, G)control and DRIVE (R, G) control during servicing.Note:* These controls are exclusively for the use of servicepersonnel. Do not attempt to adjust them yourself.1324Pin No. Signal1 GND2 —3 —4 12 V DC1234567 8UNDERSCANLINE (INPUTSELECT)OFFONBA4:3/16:9(ASPECT RATIO)16:94:3MONO(color off) OFFONEXTSYNCTALLYGNDPULSECROSSOFFONOFFONOFFON