4CONTROLS AND FEATURESFront3 4 5 611 12 13 147 8 9 10POWERUNDERSCAN PULSECROSS MONO BLUELINE ALINE B EXTSYNCNTSCPALV.HOLDNTSCPAL 4:316:9CONTRASTBRIGHTCHROMAPHASEVOLUME1 Tally lampIndicates that a control signal is being received. The tallylamp functions when the control signal is input to theTALLY/REMOTE terminal on the rear panel.2 SpeakerA built-in speaker is located inside the left side panel.3 VOLUME controlAdjusts the speaker volume.4 V.HOLD controlUse a small-bladed screwdriver to adjust the image’svertical stability.5 Picture control sectionPHASE, CHROMA, BRIGHT and CONTRAST controlsare available.The standard setting mode can be obtained by settingeach control to the center click position. To adjust asetting, insert a small-bladed screwdriver into the spacearound the knob and turn it to the desired position.When adjusting, use the small-bladed screwdriver andinsert it into the control hole around the required controlknob. PHASE controlAdjusts picture hue. CHROMA controlAdjusts picture color density. BRIGHT controlAdjusts picture brightness. CONTRAST controlAdjusts picture contrast.Notes:* The PHASE control is effective only in the NTSC colorsystem mode.* The standard CHROMA setting can be adjusted to suitthe NTSC or PAL color system.6 LINE A/B switchSelect the video signal input to the video input terminalson the rear panel.A (G): Selects the video signal input to LINE A terminal.B (g): Selects the video signal input to LINE B terminal.Note:* LINE B terminals include both S-VIDEO (Y/C) andcomposite VIDEO terminals. S-VIDEO inputs havepriority.7 EXT SYNC switchSelects internal sync or external sync.When using with the external sync, input the sync signal tothe EXT SYNC terminal on the rear panel.(G) : Internal sync(g) : External sync8 NTSC/PAL switchSelects the NTSC or PAL color system.NTSC (G) : For NTSC color system.PAL (g) : For PAL color system.9 4 : 3/16 : 9 switchSelects the aspect ratio (4:3 or 16:9) of the picturedisplayed on the screen.(G) : 4:3(g) : 16:9Note:* When a 4:3 picture is viewed in the 16:9 mode, the sizeof the image is reduced vertically.10 POWER switch/POWER indicatorPress this switch to turn the power on or off.ON (g) : Power is turned on and the power indicatorlights.OFF (G) : Power is turned off and the power indicatorgoes off.Note:* If the battery expires while the monitor is operated withDC power supply (the voltage level drops), the greenindicator changes to orange, then to red. When thePOWER indicator changes to red, the powerautomatically goes off. Make sure you switch off thepower before replacing the battery.POWERUNDERSCAN PULSECROSS MONO BLUEEXTSYNCLINE ALINE BNTSCPALV.HOLDNTSCPAL 4:316:9CONTRASTBRIGHTCHROMAPHASEVOLUMES950BT-12
