Operating Instructions2Main FeaturesIPv6*1 Network CameraYour Panasonic Network Camera supports IPv6 (Internet Protocol Version 6), IPv6was created to address the additional IP addresses that will be needed as theInternet continues to expand. Since the camera also supports IPv4 that's currentlyused, it is "dual stack" design will seamlessly operate while IPv6 is phased in. Formore information in IPv6 you wish to visit http://www.ipv6.org/. See page 15 formore information.Audio 2-way Communication*2 (Walkie-talkie Type)2-way audio communication is now possible between your Network Camera andPC. By connecting a user-supplied microphone and speaker*3 to both the cameraand to the PC, you will be able to speak to and hear anyone within range of thecamera.For example, the camera can be used in the following various locations:• In the baby's room, to hear if the baby is crying.• At the front door, to see and hear who is at the door.• In the children's play room, to see and hear if they are safe.NotePLEASE NOTE that under certain circumstances, audio/video recording maybe PROHIBITED by law. This device should be used only in compliance withall applicable federal, state and local statutes.Better Image QualityThe CCD sensor and the color night view mode provides better image quality andlow light performance.• The CCD sensor gives you clear image.• You can monitor live video (Motion JPEG) that refreshes its image 30 framesper second.• Color night view mode allows you to monitor the camera in low illuminance.*1 To connect in IPv6, subscribe to the ISP's "IPv4/IPv6 Dual-Stack" or "IPv6 over IPv4Tunneling" service. The camera does not work in IPv6-only network.*2 Audio feature does not work well on cell phones. Talk button and Listen button cannot be usedsimultaneously. In consequence of traffic and network environments, the audio may bedelayed or may break up.*3 The speaker connected to the camera requires a built-in amplifier.