121 265 mmHole for a cable25 mmFit the four rubbersin place.Fit the two dents in place.Four tabsFit the tabs to the holes andmove counterclockwise.Attach firmly with Screws A.Screws A (2 pcs.)Adjust the " " of the mainunit to the " " of the CeilingMounting Cover.Move the Ceiling MountingCover in the clockwisedirection until the " " of it fitsto the " " of the main unit.Be careful not to nip the cable etc.When removing the Ceiling Mounting Cover, move it in thecounterclockwise direction. Adjust both " " and let down themain unit.Wiring without making a hole for a cablein the ceilingDrill for concrete(in case of tile,use a drill for tile)Plastic plugSoft hammerNote1232345•••••Make a hole for a cable.Make a 25 mm holewhere is 65 mm awayfrom the center in theplate.Attach the rubbers and dents on the camera to the CeilingPlate A and attach them firmly.Attach the Ceiling Plate A to the Ceiling Plate B and attachthem firmly with Screws A.Install the camera so that the connecting part comesto the front.Connect all necessary cables (AC adaptor cord,Ethernet cable, Audio Cable or Audio/Video Cable, etc.)seeing Getting Started and attach the Ceiling Mounting Cover.Follow the steps 1), 3), 4) and 5). Making a hole is not necessary.Remove the tab of Ceiling Mounting Cover and wirethrough the notch.Ceiling Mounting when the material ofthe ceiling is mortar or concreteFit the Ceiling Plate B to the mounting positionand put marks.Make holes at the marks and put plastic plugs(customer-provided) into them.When drilling into mortar, be careful of pieces of mortarwhich may become loose and fall.Mount the camera.Mounting on the TableMount the camera at an even place on the table wherevibrations etc. are few.•Set the Mounting type setting to [On the table] on theCamera Setup page (see page 86 of the OperatingInstructions on the CD-ROM).•