Panasonic AW-RP50 Quick Start Manual

Also see for AW-RP50: Operating instructions Operating instructions Brochure & specs Brochure & specs Quick start guide

Panasonic AW-RP50 Quick Start Manual Manual pdf 2 page image

・ The [Serial] setting for serial connection cannot be set for camera numbers CAM6 – CAM100.3. Turning On AW-HE40★ After the setting-up is completed, LED button 1 at AW-RP50 CAMERA STATUS / SELECTION Area – (Fig.5) lightsup according to the camera’s power status. If the camera is in STANDBY mode (power OFF: factory default), itlights up in orange. If in POWER ON mode (power ON), it lights up in green.★ When the camera is in STANBY mode, follow the procedure below to turn on the camera.Example: Switching over to POWER ON mode (power ON) on AW-HE40 connected to CAM1① Hold down LED button 1 at CAMERA STATUS/SELECTION. – (Fig.6-A)* While the button is held down, the selected camera and its power status will be displayed on the LCD Panel. –(Fig.7)② Keeping the button held down, turn F2 dial – (Fig.6-B) to select “ON”. Then press F2 dial to determine it.* By this operation, AW-HE40 will be switched over to POWER ON mode after its default setting motion.(The status lamp will light up in green and the LED on AW-RP50 will also light up in green.)* In POWER ON mode, if you follow the same procedure and select [POWER: OFF], AW-HE40 will be switchedover to STANBY mode.CAM1＜AW-HE40 ＞POWER： OFFCAM1＜AW-HE40 ＞POWER： ON“CAM1” is held downSelect “ON” => Press F2 to determineTurn F2After setting up, this lights upaccording to the camera’spower status.* If it does not light up, please check the following points.（A）(Figure 6: AW-RP50 Control Panel) (Figure 7: LCD Panel)（B）① Check the connection state of LAN cable or whether you are using a cable that meets the specifications.② Check that the LAN cable is connected to “RS-422 port”, not to “LAN port”.③ Double-check that there is no error in setting up the connection.(Figure 5: AW-RP50 CAMERA STATUS/SELECTION Area)

/ 2

Related manuals for Panasonic AW-RP50