Panasonic AW-PH405N Operating Instructions Manual

Contents

Panasonic AW-PH405N Operating Instructions Manual Manual pdf 8 page image

8 Rotary headThis rotates in the horizontal direction. Pedestal POWER ON/OFF switchWhere a switch is pushed in, the unit’s power is turnedon, and the unit’s power is turned off after the switch hasjumped out. AC inlet [AC IN] (AC 3-point inlet)Connect the accessory AC power cable to this inlet. Camera mounting base mounting screwsM5 mm hexagon socket head screws (with flatwashers, spring washers) ( of each provided asaccessories)These parts are used to secure the camera mountingbase to the rotary arm. Tally lamp (accessory)This is lighted up red by the selected signals. Rotary arm mounting screwsM5 mm hexagon socket head screws (with flatwashers, spring washers) (4 of each provided asaccessories)These parts are used to secure the rotary arm to therotary head. Rotary armThis rotates in the vertical direction. Camera mounting baseMount the convertible camera or multi-purpose cameraon this base. Pan-tilt head mounting holesThese four holes are used when installing the pan-tilthead. Bottom panelUse the unit with this panel in position. PROMPTER connectorThe prompter is connected to this connector.The maximum current which can be supplied from the DC1 V OUT socket is .5 A.When the prompter is connected, the pan-tilt head’sspeed is reduced to about one-third.When connecting the prompter, be absolutely sure toshort-circuit the DETECT terminal (Pin No.14) and theGND terminal (Pin No.15).Note  Consult your dealer when a prompter is tobe installed since it will be necessary forthe balance between the mounting fixtureand overall weight and other aspects to bechecked.Pin layout as seen facingthe prompter connectorPin No. Signal Name1 – – –9 – – – PROMPTER VIDEO10 PROMPTER VIDEO GND – – –11 – – –4 DC 1 V OUT1 – – –5 GND1 – – –6 – – –14 DETECT7 – – –15 GND8 – – – Guide pinUse this to determine the direction in which the camera isto be mounted. Camera mounting screws (U1/4” 20UNC)These are used to secure the camera firmly after it hasbeen mounted. Side blank panelFor normal operation, use the unit with this panel inposition.Parts and their function