16Installation Pan-tilt head mounting conditionsPan-tilthead weightMountingspecificationsCompatiblecamerasCameraweightCameraanti-dropmeasuresCompatiblelenses Lens weight Cableweight Total weightApprox. lbs(10 kg)Stand-aloneinstallation orinstallation onthe cellingConvertiblecamera seriesAW-E50AW-E650AW-E655AW-E750AW-E860Approx..6 lbs(1. kg)max. Wire providedused formountingAW-LZ16MD55PAW-LZ16MD7PAW-LZ17MD9AGApprox. .9 lbs(1. kg) max. Approx.0.7 lbs(0. kg)Approx.8.7 lbs(1 kg)Multi-purposecamera seriesAK-HC1500GApprox.. lbs(1.5 kg)HA1 seriesHA seriesHJ17e seriesHJ1e seriesApprox. 7.1 lbs(. kg) max.Approx..1 lbs(15 kg)Mounting the pan-tilt headRecommended screws No. of screwsM6 screws (hexagonal nuts) 4 pcsNotes Refer to the above table for the total weight of the pan-tilt head with the camera, lens, cables and anyother accessories installed.Install the equipment on an installation surface which is capable of ensuring a drop safety equivalent tofive times the figure for the total weight. The maximum weight of the units which can be installed on the pan-tilt head is .1 lbs (15 kg) or so[or approximately 55.1 lbs (5 kg) total for the weight of the pan-tilt head and weight of the unitsinstalled on the head]. When mounting the pan-tilt head on which units have been installed, be sure tomount it on an installation surface which is itself capable of ensuring a satisfactory drop safety. Installing the pan-tilt headBefore installing the pan-tilt head, check that the above mounting conditions are satisfied, and observe the following precautions.In order to prevent accidents resulting when the product becomes dislodged or falls down, be absolutely sure to proceed asinstructed. Do not install the pan-tilt head on its side since its prescribed operation and performance cannot be ensured. After the pan-tilt head has been installed, mount the camera on it. When installing the pan-tilt head, use the four mounting holes to secure the pan-tilt head firmly. Ensure that the surface on which the pan-tilt head will be installed and the anchor bolts used are sufficiently strong. Use the M6 hexagon head bolts (including one short bolt) for installation. Use hexagon head bolts which are longer than the thickness (t) of the mounted member + 1” (5 mm). As shown in the figure of next page, use flat washers, spring washers and hexagon nuts for the hexagon head bolts. Use a wrench of the appropriate size to tighten up the hexagon head bolts. Provide a wire which is strong enough to support the combined weight of the entire pan-tilt head system (which consists of thepan-tilt head, camera, lens and cable). Do not use a surface made of plaster board or wood as this kind of installation surface will not be strong enough. If mountingon such a surface is unavoidable, take sufficient anti-drop measures. Install the pan-tilt head in such a way that the equipment and cable attached to it will not make contact with any surroundingobjects when the head is swiveled. When the unit is no longer going to be used, do not leave it in place, and be absolutely sure to remove it.