Panasonic AW-HS50 Quick Start Manual

Also see for AW-RP50: Operating instructions Operating instructions Brochure & specs Brochure & specs Quick start guide

Panasonic AW-HS50 Quick Start Manual Manual pdf 1 page image

★ A highly efficient operating environment can be established by linking AW-HS50 switcher and AW-RP50 controllertogether. (Only one AW-HS50 switcher can be linked.)This is to explain how the devices are to be connected and what features are made available by this linkage.Features Available by This Linkage- Switching the Sources: The sources on AW-HS50 can be switched in tandem with the camera selecting operationsby AW-RP50. * Controllable buses: AUX, PVW, PinP, KEY-F- Focus Assist Function: It is possible to switch between the Multi View Display (MV) and a full-screen display ofcamera output image by a single AW-RP50 button operation. * Controllable bus: AUX- Displaying the Camera Icon: A camera being controlled by AW-RP50 can be indicated with the camera icon ( )on the MV screen by AW-HS50.- Displaying the Camera Information: The setting information of a camera can be displayed on an AW-HS50 AUXoutput image or the MV screen.- Getting the Tally Information: Tally information can be output to a camera selected using AW-HS50 PGM.- Changing the AW-HS50 Settings: Setting values on AW-HS50 can be changed using the PAN/TILT lever andZOOM button on AW-RP50.Connection Procedure and Type of Cable① Connect AW-HS50 and AW-RP50 using a LAN cable.* Connecting directly: crossover cable Connecting via a hub: straight cable, category 5 or higher, up to 100m★ Configuring AW-HS50① Hold down the OSD ON button – (Fig.1-A) for two seconds to open the menu. (To close it, hold the button downagain for two seconds.)② Use the OSD/TIME dial – (Fig.1-B) to change the menu setting below so that the functions linked up withAW-RP50 are enabled.Menu: [13] Output Menu > 10. CamContLink => [On] – (Fig.2) * Default: OffLinked-Up Functions of AW-HS50 and AW-RP50【Step 1】 Making the linked-up features ready