Panasonic AW-HS50 Quick Start Manual

Also see for AW-HS50 Series: Operating instructions Operating instructions Brochure & specs Quick start guide Manual

Panasonic AW-HS50 Quick Start Manual Manual pdf 1 page image

★ This is to explain AW-HS50 switcher’s basic setup and how to deal with problems (e.g. no image output) when theyoccur.■ Display of Menu Screen (OSD: On-Screen Display)The menu screen is displayed by holding down OSD ON button – (Figure 1). It is superimposed on the image outputfrom SDI OUT 2 connector and DVI OUT connector.(To clear the menu, hold down OSD ON button again.) * The menu screen is not output from SDI OUT 1 connector.Turn OSD dial to select the setting, and press the dial to enter the selection. The setting value can be varied by turningthe dial while the value is blinking.■ Settings for CrosspointA source is selected by pressing one of A bus or B bus crosspoint buttons. It is the signal which has been set inadvance using the menu, and called up as the source.Assignment to the crosspoint buttons is carried out using the menu: [9] XPT SW Assign Menu – (Figure 2).By factory default, pressing the crosspoint button 1 will make the unit call up the source input into “SDI-IN1”.If XPT6 – XPT10 need to be called up, press the crosspoint buttons while SHIFT button is held down.AW-HS50 – Basic Operations & Troubleshooting(Figure 1: AW-HS50 Control Panel)(Figure 2: Menu Screen for [9] XPT SW Assign Menu *factory default)A bus crosspoint buttonsOSD ON buttonONSHIFT buttonB bus crosspoint buttonsOSD dialONBUS DELEGATION buttonsFTB ON buttonON

/ 4

Related manuals for Panasonic AW-HS50 Series