|
16Notification when the power is turned on for the first timeNotification when the power is turned on for the first timeWhen using the products for the first time, connect the Control Panel AV-HS60C1/AV-HS60C2/AV-HS60C4 to the terminal of the Main FrameAV-HS60U1/AV-HS60U2, and then turn on the power.Depending on the combination of the purchased Main Frame and the Control Panel, the version of the firmware for each may not match.When the version of the firmware for the Main Frame and the Control Panel does not match, the Control Panel will not correctly boot when the power isturned on.Boot status when the versions do not matchTwo buttons out of PST/B bus crosspoint buttons in the ME line in front will blink. One button will blink in green, and the other will blink in red. (Fig. 1)BUSSHFTGreen RedFig. 1f When it goes into this status, it is necessary to match the firmware version of the Control Panel to the Main Frame.f If it does not go into this status and the Control Panel boots normally, the firmware versions of the Main Frame and the Control Panel do match.f Check the latest software information and perform the version update of the software if necessary. For details, refer to “To perform the version updateof the software” (page 16).r To match the firmware version of the Control Panel to the Main FrameThe firmware of the Control Panel is updated when the following operation is performed. Once the update is correctly performed, the firmware version ofthe Control Panel will match with the firmware version of the Main Frame, and it will boot in normal status.RECALLSTOREDELCHR LIN FULL FULLWIPE01s00fMIX01s00fMIX01s00fMIXCG5V CG6V CAM1 CAM201s00fMIX ME201s00fBUSSHFT4-1 4-34-24-4 4-64-54-7 4-94-8OPSTILL1BUSSHFT4SDIIN33SDIIN22SDIIN11Black121110SDIIN99SDIIN8SDIIN11SDIIN108SDIIN77SDIIN66SDIIN55SDIIN4Red RedBlueFig. 2 Fig. 31 Press the button blinking in red (Fig. 1).Update of the firmware is started.f Status when the firmware of the Control Panel is being updated (Fig. 2)- Eight buttons out of the PGM/A bus crosspoint buttons in the ME line in front will repeatedly blink in blue from left to right.- Eight buttons out of the PST/B bus crosspoint buttons in the ME line in front will blink in red sequentially from left to right.Update of the firmware will complete after approximately two minutes.f Status when the update of the firmware of the Control Panel is completed- Eight buttons out of the PST/B bus crosspoint buttons in the ME in front will continue to blink in red. (Fig. 3)- Depending on the version of the firmware of the Main Frame, the Control Panel may automatically reboot. The firmware of the Control Panel isupdated correctly for this too.2 Turn off the power of the Main Frame and the Control Panel.f Turn off the power after completing the update of the firmware of the Control Panel.f Do not turn off the power of the Main Frame and the Control Panel while the firmware of the Control Panel is still updating (Fig. 2).3 Turn on the power of the Main Frame and the Control Panel.Control Panel is booted and the menu screen is displayed in the menu panel when the firmware is correctly updated.4 Select the button → [MAINTENANCE] → [Boot] tab → [Initial] column → [Initial] button.5 Select [OK] in the confirmation screen.The AV-HS6000 is initialized.Go on to the procedure in “To perform the version update of the software” (page 16).r To perform the version update of the softwareCheck the latest software information and perform the version update of the software if necessary.1 Check the button → [MAINTENANCE] → [Status] tab → [System Version] column → [System Version].
|
