|
14Part Names and FunctionsRear panelMENU PANELMAIN FRAME GPI I/OCOM1 (M) COM2 (RS-232)DVI-D USB2 3 54 6 7 8 9110 111 / terminals (signal: AC)Connects one end of the supplied AC cable to this terminal and the other end to the AC outlet. (AC 100 V to 240 V, 50 Hz/60 Hz)f The supplied AC cable has a 3-pin plug with a grounding terminal. Connect to a 3-pin power outlet which is equipped with a grounding terminal.f If a 3-point power outlet is not available, be sure to consult your dealer.2 terminal (connector: RJ-45/signal: 100Base-TX)Connects to the terminal or terminal of the Main Frame AV-HS60U1/AV-HS60U2.f When connected to the terminal, no video will be displayed on the Menu Panel AV-HS60C3.3 Connects the Menu Panel AV-HS60C3.f Cannot be used concurrently with a DVI monitor (computer) connected to the terminal. Select with the display selector switch.f This is the dedicated interface for the Menu Panel AV-HS60C3. Do not connect with DVI output devices.4 Display selector switchSwitches the terminal to be used to the Switch this when the power is off. Output will not be performed properly if switched with the power turned on. Restarting of the unit will be necessary.Set the power to , and then set it back to .5 terminal (connector: DVI-D/signal:DVI OUT)Connects the DVI monitor (computer) used for the menu display.f Monitor resolution: 1366×768 compatible monitorf Cannot be used concurrently with the 6 terminal (connector: USB (type A, female)/signal: USB)Used for the menu operation of the DVI monitor (computer).f Cannot be used for the Menu Panel AV-HS60C3.7 terminal (connector: D-sub 9-pin (female), inch screw/signal: RS-422)Used for master connection of external devices.8 terminal (connector: D-sub 9-pin (male), inch screw/signal: RS-232)Used to control external device.9 terminal (connector: D-sub 25-pin (female), inch screw/signal: GPI)Equipped with 8 contact input ports (GPI IN) that control the unit externally, 10 output ports (GPI OUT) that output tallies or status information fromthe unit, and an alarm output port (ALARM OUT).10 / terminals(Fuse)11 terminal (signal: SG)Connects to the ground of the system.@@ NOTEt For the cable connecting to the terminal, use a double-shielded cable.t For the cable connecting to the terminal, / terminal, and terminal, use a shielded cable.t The terminal and the terminal cannot be used with the sub control panel.
|
