12ME Live Switcher AV-HS6000Firmware Upgrade GuideFollow the steps below to upgrade the AV-HS6000 software version.1. Check the software version2. Save project files3. Upgrade the Main Frame4. Upgrade the Control Panel5. Verify the software version6. Initialize the AV-HS60007. Load project filesThis document describes menu operations via the Menu Panel, but you can perform the same operations via a standard DVImonitor and mouse. Refer to “Chapter 4 Preparations – Basic menu operations” in the Operating Guide.A memory card is required to upgrade the AV-HS6000 software version.pp There must be at least 200 MB of free space on the memory card.pp SDXC memory cards are not supported.pp Use a memory card that has been initialized on the AV-HS6000 beforehand. Refer to “Chapter 5 Basic Operations – Storage Initializing a memory card ” in the Operating Guide.Important Notes Notes on network settingsThe following settings will be initialized when upgrading from Ver. 3 or earlier of the AV-HS6000 software.pp button [SYSTEM] [Network] tab [Network1] column settingpp button [SYSTEM] [Network] tab [Network2] column settingpp button [CTRL PANEL] [SubPanel1] tab [Network] column settingpp button [CTRL PANEL] [SubPanel2] tab [Network] column settingThe above settings are not saved to project files.Make a memo of the settings before upgrading the software, and reconfigure the settings after upgrade is complete. Notes on macro data compatibilityMacro data which stores menu operations performed after pressing the button or button may not play backproperly after upgrading the software.Delete macro register memories that contain such recorded operations after upgrading the software, and perform andregister the operations again.In addition, when upgrading from Ver. 2 of the software to Ver. 3, macro data compatibility issues other than menu operationsperformed after pressing the button or button may occur.For details, see “Appendix: Notes on Upgrading from Ver. 2 to Ver. 3” on page 5.W0614TY3066 -FJ VQT5L08-3