714-9. Understanding RAW output feature10-bit RAW data output is available for the greatest flexibility in post image adjustment. The RAWdata is output from SDI OUT (RAW data cannot be recorded with the built-in recorder in the EVA1).Settings to use RAW data output1. Set output mode in MENU > SYSTEM SETTINGS > SYSTEM MODE > SDI RAW item.Available maximum frame rate for variable frame rate record (VFR) and view angle vary asdescribed in the chart below.SDI RAW menu Description Max. fpsS35 5.7K Use entire active plane of the imager, and output RAW datafrom all active pixels (5760x3072). 30fpsCROP 4K Use a part of the imager, and output RAW data from all activepixels within the part (4096x2160). 60fpsCROP&MIX 2K Use a part of the imager, and generate RAW data(2048x1080) by mixing pixels. 240fps2. Connect a recorder (support EVA1’s RAW data record) to SDI OUT and record.*Output data resolution and maximum available frame rate (for variable frame rate record mode)vary by settings in the chart below.FREQUENCY SDI RAW VFR23.98p, 24.00p, 29.97pS35 5.7K (5760x3072 pixels) 1 – 30fpsCROP 4K (4096x2160 pixels) 1 – 60fpsCROP&MIX 2K (2048x1080 pixels) 1 – 240fps25.00pS35 5.7K (5760x3072 pixels) 1 – 25fpsCROP 4K (4096x2160 pixels) 1 – 50fpsCROP&MIX 2K (2048x1080 pixels) 1 – 200fps50.00p CROP 4K (4096x2160 pixels) 1 – 50fpsCROP&MIX 2K (2048x1080 pixels) 1 – 200fps59.94p CROP 4K (4096x2160 pixels) 1 – 60fpsCROP&MIX 2K (2048x1080 pixels) 1 – 240fps59.94i, 50.00i No RAW data out available6G SDI x14. Understanding advanced featuresS35 5.7KCROP 4K, CROP&MIX 2KImage plane