Panasonic AKHCU200 Operating Instructions Manual

Also see for AK-HCU200E: Operating instructions

Contents

Panasonic AKHCU200 Operating Instructions Manual Manual pdf 11 page image

11Setting menu itemsTOP MENUThis is the first screen displayed when you hold down the MENU buttonSelect one of the menusTOP MENUOPERATIONMAINTENANCEzz OPERATIONSelect this to open the OPERATION menu screenzz MAINTENANCESelect this to open the MAINTENANCE menu screenOPERATION menuThis is the selection screen for the OPERATION menuMoving the cursor to the “OPERATION” menu title and then pressing theSELECT dial redisplays “TOP MENU”OPERATIONSETTING1SETTING2HD/SD PHASEBAR IDINCOM/MICzz SETTING1Select this to display the SETTING1 screenzz SETTING2Select this to display the SETTING2 screenzz HD/SD PHASESelect this to display the HD/SD PHASE screenzz BAR IDSelect this to display the BAR ID screenzz INCOM/MICSelect this to display the INCOM/MIC screenzz SETTING1 ScreenThis is the selection screen for the SETTING1 menuMoving the cursor to the “SETTING1” menu title and then pressing theSELECT dial redisplays the OPERATION menu one level upSETTING1CCU MODE 1080/59.94iSDI RETURN1 HDSDI RETURN2 HDSDI OUTPUT1&2 HDSDI OUTPUT3&4 HDNORMAL/PM PMCOMPOSITENORMAL/PM PMindicates the factory default settingItem Settingvalue RemarksCCU MODE 59 94 Hz:1080/59 94i1080/50iSet the format of the signal to be outputfrom the unit50 Hz:1080/59 94i1080/50iSDI RETURN1 HDSDSet the format of the return signal to beinput to [HD/SD SDI 1] of the RETURNIN connectorsSDI RETURN2 HDSDSet the format of the return signal to beinput to [HD/SD SDI 2] of the RETURNIN connectorsSDI OUTPUT1&2 HDSDSet the format of the signals to beoutput from [1] and [2] of the HD/SDSDI OUT connectorsSDI OUTPUT3&4 HDSDSet the format of the signals to beoutput from [3/PM] and [4/PM] of theHD/SD SDI OUT connectorsSDI OUTPUT3&4NORMAL/PMNORMALPMSet the signal to be output from [3/PM]and [4/PM] of the HD/SD SDI OUTconnectorsNORMAL:Output the main line imagesPM:Output the picture monitor imagesCOMPOSITENORMAL/PMNORMALPMSet the signal to be output from[OUT/PM] of the VBS connectorsNORMAL:Output the main line imagesPM:Output the picture monitor imageszz When the SDI OUTPUT3&4 NORMAL/PM item and COMPOSITENORMAL/PM item are set to “NORMAL”, the menus and statuses willnot be able to be displayed because the picture monitor images willnot be outputWhen one of items is set to “NORMAL”, the other one is set to “PM”as both of the items cannot be set to “NORMAL”