41System connection diagram (continued)Connecting to a camera recorder IP connectionTo determine whether a camera recorder can be connected using IP connection, please see the Operating Instructions for the camera recorder or visitthe following Web site.http://pro-av.panasonic.net/12V IN LAN RS-422 PREVIEWCCUSIGNAL GNDPersonal computerAK-HRP200LAN cable(straight cable)AJ-PX***VARICAM AJ-PX***LAN cable(straight cable)LAN cable(straight cable),up to 100 mSwitching hub(100base-TX)External DCpower supply1. Connect the IP connector of this unit and LANconnector on the camera recorder with a LAN cable(option).• When connecting via a switching hub (100base-TX), use a straightcable (category 5 or better shielded cable) for the LAN cable. Whennot connecting via a switching hub, use a cross cable (category 5 orbetter shielded cable) for the LAN cable.2. When you have finished connecting the equipment, turnon the power of the camera and turn on the external DCpower supply of the unit.• Up to 19 camera recorders and remote cameras can be controlledfrom this unit.• To use a remote camera via an IP connection, you need to configurethe settings with ROP Setup Software (accessory). Please make surethat the version of the ROP setup software is Ver. 3.0.0.0 or higher.*1Before using ROP Setup Software, connect the unit to the personalcomputer with a LAN cable.• With IP connections, the unit can coexist with a CCU. For how toconnect to a CCU via an IP connection, refer to (→page 36).• For details on the settings for IP connections, refer to Operations andSettings on the supplied CD-ROM.Please refer to the latest OperatingInstructions at the following Web site.http://panasonic.biz/sav/manual/index.html*1 Please visit the following Web site for the latest software information.http://pro-av.panasonic.net/