27Parts and their functions (when operating a camera recorder)This section describes the operation of camera recorders (AJ-PX*** series).Operation panelA beep (buzzer) sounds when a button is pressed. However, buttons do not beep when the buzzer is set to Off in setup mode.AUTOBLACK SET UPWHITEBARSTESTVFPOWERHEADPOWERDTLOFF SHUTTERONSTEP/SYNCKNEEOFFSKINDTLMATRIX5600K1 2 3 4 5 67 8 9 10 11 121. Camera power button Indicates the power status and IP/serial connection status of thecamera recorder.It cannot be used to turn the camera recorder's power on or off.On (green): The camera is turned on.Flashing(green):The network/serial connection of the camera isdisconnected.Short flashes(red)*1:Network authentication not completed in IP connectionmode.Off: The camera is turned off.*1 Short flashes have an interval of about 0.5 second.• During network/serial connections, the connection can be brokenby pressing the power button. When the connection is broken, thepower button flashes (green).• Short flashes (red) indicate a network authentication error. Recheckthe User Name and Password settings in the User Auth. tab of theROP setup software.2. Viewfinder power button This cannot be used with a camera recorder.3. Color Bar Signal Output button The color bar signal and TEST signal are output from the camera.On (green): TEST signal On*1Off: Color bar OffOn (yellow): Color bar On*1 Not supported by all devices.4. Auto White Balance button Use this button to automatically adjust the white balance.On: Indicates that the auto white balance adjustment hasstarted.Flashing: Warns that the automatic white balance adjustment endedwithout being completed.Off: Indicates that the white balance has been adjustedcorrectly.5. Auto Black Balance button Use this button to automatically adjust the black balance.On: Indicates that the auto black balance adjustment hasstarted.Flashing: Warns that the automatic black balance adjustment endedwithout being completed.Off: Indicates that the black balance has been adjustedcorrectly.6. Auto Setup button This cannot be used with a camera recorder.7. 5600 K button <5600K>This cannot be used with a camera recorder.8. Matrix button Use this function to correct saturation and color phase according tothe gain setting of each color component in matrix memory. Eachpress of the button turns the function on or off.On: ONOff: OFFThe initial status following power on depends on the camera recordersettings.9. Skin Detail button Use this button to apply coring to the detail enhancement of the skintone areas to soften or increase the enhancement of skin tone details.On: ONOff: OFFThe initial status following power on depends on the camera recordersettings.10.Knee OFF button Use this button to cancel the knee function that attenuates thoseareas of the video signals where a particular level (knee point) hasbeen exceeded so that they will not become saturated as easily.On: Knee function is canceled. (Knee OFF)Off: Knee function is on.11.Detail OFF button Use this button to disable the contour enhancement (hard/soft)function (detail enhancer) of image output.On: Detail enhancer offOff: Detail enhancer on12.Shutter On/Off button STEP/SYNC select button Use thus button to turn the SHUTTER on or off. Press and hold thebutton to switch between STEP and SYNCHRO. In SHUTTER ONmode, the SHUTTER display select button and theSHUTTER display light, and the setting is displayed on thesetting display for about 2 seconds.On: SHUTTER ON (STEP/SYNCHRO can be selected)Off: SHUTTER OFF (STEP/SYNCHRO can be selected)• Whether shutter speed settings in SYNCHRO mode are displayedin seconds (sec) or as an opening angle (deg) depends is selectedthrough the setup mode 22 synchro shutter display setting menu.• STEP/SYNCHRO switching cannot be performed during SHUTTEROFF mode.
