Panasonic AJ-YAC77P Installation Manual

Contents

Panasonic AJ-YAC77P Installation Manual Manual pdf 5 page image

13P4NTSC13P4PALBlackRedYellowS_IN1S_OUT2REF_INJumper setting diagram Coaxial cable connection diagramAfter setting NTSC or PAL for the P4 pin of the accessory SDTI board as shown in the jumper settingdiagram, refer to the coaxial cable connection diagram and connect the coaxial cables. The connectionswith the board should be made in the following order:1 Connect the coaxial cable (black) which was connected in step 7 to the S_IN1 connector on the SDTIcard provided with the unit.2 Connect the coaxial cable (red) which was connected in step 7 to the S_OUT2 connector on the SDTIboard.3 Connect the coaxial cable (yellow) provided with the unit to the REF_IN connector on the SDTI board.Remove the 20-pin remote cable shown at rightfrom the Remote I/O board connector followed bythe 3 screws, then remove the board metal clampfrom the Quick Cutter unit.(For AJ-DE77H and AJ-DE77D, also remove the 2screws and the fan as shown in the diagram atright. It is not necessary to remove the fan’s powercable.)InstallationRemove the cable and screw shown in the diagram atright, then remove the X4PCI board from the slot.Insert the accessory SDTI board into the slot which hadaccommodated the X4PCI board, secure it using thescrew, and connect the cable that was disconnectedfrom the X4PCI board to the connector of the SDTIboard.Connect one end of the coaxial cable (yellow), which wasconnected in step 11, to the J7 connector on the TRVinterface board.-5-Replace the board metal clamp (and the fan for AJ-DE77H and AJ-DE77D) removed in step 12 andsecure it with the 3 screws.Connect the 20-pin remote cable removed in step 12 to the Remote I/O board connector.YellowJ7Screws(x3)ScrewEnlarged viewEnlarged viewCableScrews (x2) for AJ-DE77H orAJ-DE77D only20-pin remote cableBoard metal clampFan

/ 8

Related manuals for Panasonic AJ-YAC77P