Panasonic AJ-YAC77P Installation Manual

Contents

Panasonic AJ-YAC77P Installation Manual Manual pdf 4 page image

After threading the coaxial cables connected to the terminal boardthrough points 1 and 2 as shown at right, replace the jack panelon the main unit.(AJ-DE77 only)Remove the two screws and two hexagonal bolts of the AVinterface connector at the bottom rear of the Quick Cutter andremove the TRV interface board together with its metal clamp.Installation(AJ-DE77 only)Remove the four screws securing the TRV interface board and metal clamp,and replace the board with the accessory TRV interface board, then use thefour screws to secure the metal clamp.(AJ-DE77 only)Use two screws and two bolts to secure the metal clamp, which wasattached to the TRV interface board, to the Quick Cutter unit.-4-Screws (x2) Hexagonal bolts (x2)Screws (x2)Hexagonal bolts (x2)Screws (x4)Enlarged view11 Pass the cable through the oval-shaped hole.22 Pull the cable out from the position shown.AV I/F