705-1-2 Using an AC Power SupplyWhen using the Panasonic AJ-B75 AC adapter1 Plug the AJ-B75 DC OUT connector into the camera-recorder’s external DC input socket.2 Turn the AC adapter power ON.3 Turn the camera-recorder power switch ON.z When both the battery pack and AC adapter areconnected, power is supplied from the AC adapter. Thebattery can be removed or mounted while using the ACadapter.z When using the AC adapter, make sure you turn ON theAC adapter power before turning ON the camera-recorder’s power switch. If this sequence is reversed, thecamera-recorder may malfunction due to slow rising ofthe AC adapter output voltage.z When connecting a battery to the DC IN socket, selectthe battery type listed under EXT DC IN SELECT. SelectEXT DC IN SELECT from the screen on the MAIN OPERATION page. In this case,however, the % display is disabled, even when using adigital battery.5-2 Mounting the Viewfinder andAdjusting its PositionPlease refer to the viewfinder instruction manual.Note: A slide rail is required to mount any viewfinder other thanmodels AJ-VF15B or AJ-VF20WB.z If you need to buy a slide rail, please contact the store whereyou purchased the camera-recorder and tell them that theslide rail is a “repair part”.Slide rail (VFC3995)Screws (XBS3+8VZ)Mounting the Slide Rail1 Undo the upper two screws for AJ-VF15 or AJ-VF20W, andremove the mounting unit.Leave the screws attached to the mounting unit.2 Mount the slide rail, then tighten the two screws.DC IN SocketAC Adapterz AJ-B75 (Optional)When using an external power supply other than the ACadapter AJ-B75, check the DC IN socket pin information toensure correct polarity. If a +12V power supply isaccidentally connected to the GND terminal, this couldcause a fire or personal injury.1234 Pin No. Signal1 GND2, 3 —4 +12VDC IN SocketMounting unitScrewsSlide railᤨࠫDownloaded From CamcorderManual.com Panasonic Manuals
