76 P2 Playlist Editing ModeP2 Playlist Editing ModeStarting the application (P2 Playlist Editor) from the Web browserWhen the network connection with the mobile device or computer is established, start the browser on the mobile device or com-puter and then start the application (P2 Playlist Editor).1 Press the [MODE] button when the unit is in the idle state.2 Align the cursor(*) with “PLAYLIST” in the selection screen and press the [SET] button.“PLAYLIST” flashes on the LCD monitor and the modes changes. When the mode changes, “PLAYLIST” appears in the ad-ditional information display area on the LCD monitor.3 Start the browser (Safari or Internet Explorer) on the mobile device or computer.4 Enter the IP address set for the unit in the address bar of the browser.• Factory default setting: 192.168.0.15 Press the Enter key in the case of a computer and tap the GO button in the case of an iPad or iPhone.The Web application (P2 Playlist Editor) starts.6 When the authentication screen appears, enter the user name and password in the input screen.Enter the value set for “USER ACCOUNT" (factory default setting: guest) and the value set for “PASSWORD” (factory defaultsetting: p2guest) on the unit.The connection is established when the screen in Figure 1 appears.You can set a user account name and password in the “I/F SETUP” - “NETWORK” - “NETWORK FUNC” - “USER ACCOUNT”(➝ page 98) menu setting.You can register a new account, delete an account, or change a password in the “I/F SETUP” - “NETWORK” - “NETWORKFUNC” - “ACCOUNT LIST” (➝ page 98) menu setting.The user account name can be up to 31 characters long and the password can be from 6 to 15 characters long.For information on P2 Playback Editor, refer to Operating Instructions of P2 Web Application available from the followingwebsite.http://pro-av.panasonic.net/en/manual/index.htmlFigure 1