Panasonic AG-HPX500P Operating Instructions Manual

Also see for AGHPX500E - MEMORY CARD CAMERA RECORDER: Operating instructions Service manual Quick manual Parts list Operating instructions

Contents

Panasonic AG-HPX500P Operating Instructions Manual Manual pdf 33 page image

33Basic ProceduresChapter 3 Recording and PlaybackThis section describes the basic procedure forshooting and recording.Before you embark on a shoot, pre-inspect yoursystem to ensure that it works properly.For directions on inspecting your memory cardcamera-recorder, see [Inspections Before Shooting].Battery Set-up to P2 card Insertion1 Insert a charged battery pack.2 Turn the POWER switch to ON to checkthe battery remaining level in theviewfinder.• When battery level drops, first check thebattery setting, and if the battery settingis correct, replace the battery with a fullycharged battery.3 Insert a P2 card and ensure that the P2CARD ACCESS LED stays on in orangeor green. Then, close the slide-outdoor.• When more than one P2 card slot contains aP2 card, the card in the slot with the lowestnumber is used first. However, regardless ofslot number, a P2 card inserted later will notbe accessed until the other cards have beenused.Example: If all four slots contain P2 cards,the cards are used in order of slotnumbers 1→2→3→4. However, if theP2 card in Slot 1 is removed andthen re-inserted, the cards will beused in the following order: 2→3→4→1.��Note that the recording order is retained even if thepower is turned off. When the power is next turned on,the last card written before powering-down will be thetarget card.Basic Procedures