Panasonic AG-HPX300 Operating Instructions Manual

Also see for AG-HPX300: Brochure & specs

Contents

Panasonic AG-HPX300 Operating Instructions Manual Manual pdf 126 page image

126 Manipulating Clips with Thumbnails : Setting of Proxy (optional)By attaching the video encoder card (AJ-YAX800G,optional) either to the optional slot or Slot 5, it is possible tospecify the proxy recording setting.The video encoder card is not recognized when inserted ifthe power for the unit is turned ON. Insert the video encodercard after turning off the power for the unit.Select OPERATION > DEVICE SETUP > PROXY fromthe thumbnail menu to specify the setting.For the method of installation and the settings of the videoencoder card, refer to the operation manual of the videoencoder card.NoteTo use the proxy function in 24PN (Native) mode, the FPGAversion of the video encoder card firmware must be updatedto [B102] or higher. For the method to confirm the FPGA ver-sion of the video encoder card firmware, refer to [VideoEncoder Card Status Display (optional)] (page 132). Forinstructions on updating, refer to the P2 support page on thefollowing website.https://eww.pavc.panasonic.co.jp/pro-av/1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Press the THUMBNAIL MENU button and selectOPERATION > FORMAT from thethumbnail menu.The following screen appears. Select the slot numberfor the P2 card you want to format.Select EXIT if formatting is not required.3 The following screen appears. Use the cursor buttonsand the SET button to select YES.4 The selected P2 card is formatted.Setting of Proxy (optional)Formatting a P2 Card