122 Manipulating Clips with Thumbnails : Reconnection of Incomplete ClipsIncomplete clips may be generated when clips recorded onmultiple P2 cards (connected clips) are separately copiedto different cards. Reconnection function generates oneclip (the original, connected clip) from incomplete clips.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Use the cursor and SET button to select incompleteclips to reconnect.Usually, thumbnails of incomplete clips (clips withmarker) are displayed in line.3 Press the THUMBNAIL MENU button and selectOPERATION > RE-CONNECTION from thethumbnail menu.4 The confirmation window appears. Use the cursorbuttons and SET button to select YES.Notesz indication stays illuminated until all the incompleteclips that comprise the original clip are reconnected.z The incomplete clips that were produced by removingthe P2 card during LOOP REC cannot be connectedunless all clips comprising the original clip are available.Selected clips can be copied to the P2 card or SD memorycard in the desired slot.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Use the cursor buttons to move the pointer to thedesired clip and press the SET button.3 Press the THUMBNAIL MENU button and selectOPERATION > COPY from the thumbnail menu.Select Slot 1-5 or SD memory card as the destination.4 The confirmation window appears. Use the cursorbuttons and SET button to select YES.Notesz Do not turn off the power or remove a P2 card while datais being copied. Doing so may cause the P2 card to fail.If you should accidentally perform one of the aboveoperations, defective clips will be generated. Deletethem, and then copy them again.z When clips are copied to P2 cards, all the information onthe clips is copied. However, when they are copied to theSD memory card * 1 , video and sound information is notcopied, only thumbnails, clip metadata, icons, VoiceMemo, proxy, and real-time metadata.z When there is insufficient recording capacity on thedestination, the message “LACK OF REC CAPACITY” isdisplayed, and copying will not proceed. When clips tobe copied include some with defects, the message“CANNOT ACCESS” is displayed, and copying will notproceed. If selected clips include any that are alreadyrecorded on the destination P2 card, copying will notproceed.z To stop copying, press the SET button. Clips currentlybeing copied to the destination will be deleted.z When identical clips exist on the destination card, the“OVERWRITE?” is displayed. Select “YES” or “NO”.*1 Regarding SD memory cards to be used, see in using SD memory cards> (page 22).Reconnection of Incomplete ClipsCopying Clips
