| 
– 116 –Chapter 5 Shooting — Adjustable settings when shootingAuto focusingPerforms automatic focusing while the button is pressed during manual focus mode.Manual focus assist modeYou can switch from the manual focus mode to the manual focus assist mode by setting the [CAMERA] menu → [SW MODE] → [MF ASSIST] → [ON].f Compared to the manual focus mode, you can adjust the focus (course adjustment) by rotating the focus ring approximately a half-turn.f After adjusting with the focus ring, the focus is automatically adjusted (fine adjustment).f When the focus deviation is great, it may not be in focus.f After executing auto adjustment, it will not adjust automatically until you move the focus ring again.Area mode functionTouch the subject to apply various effects tailored to the subject that is touched.f Area auto focus functionAdjusts the focus automatically tailored to the subject that is touched.f Area auto iris level functionAdjusts the iris automatically tailored to the subject that is touched.f Area brightness displayDisplays the luminance level of the subject that is touched.Operation function settingsSets the operation to be assigned to the area mode function from the [CAMERA] menu.1 Select the desired function in the [CAMERA] menu → [SW MODE] → [AREA MODE].f [INHIBIT]: Does not assign a function.f [FOCUS]: Sets the area focus functionf [IRIS]: Area iris functionf [Y GET]: Area brightness displayf [FOCUS/IRIS]: Simultaneous operation of the area focus function and area iris functionf [FOCUS/Y GET]: Simultaneous operation of the area focus function and area brightness displayOperation of area mode functionThe function set in the [CAMERA] menu → [SW MODE] → [AREA MODE] can be used by performing the following operation when shooting or while inshooting standby.1 Press the USER button to which the function set in the [CAMERA] menu → [SW MODE] → [AREA MODE] is assigned or touch theUSER button icon.f The area frame is displayed, and the is displayed on the right side of the screen.f When the area brightness display is activated, the brightness display in the center does not operate.2 Touch the shooting screen.f The area frame is displayed in the area that is touched to apply the effects set in the menu.3 Press the USER button or the USER button icon again.f The area frame disappears and the camera exits the area mode function.@@ NOTEt The area mode function is cancelled when the power is turned off or when the thumbnail screen is displayed. |
