Panasonic ACXF60-03410 Installation Manual

Also see for ACXF60-03410: Installation manual

Upper caseGaps1. R e m o v e t h e r e m o t e c o n t r o l l e r 1 m o u n t i n g p l a t e .(Insert a fl at-tipped screw driver or similar tool 3/32" to 1/8" (2 to3 mm) into one of the gaps at the bottom of the case, and twistto open. Refer to the illustration at right.)Be careful not to damage the mounting plate.2. Do not remove the protective tape which is affixed to theupper case circuit board when removing the remote controllermounting plate.3. Secure the mounting plate to an outlet box or wall. Refer to (A)or (B) instructions below depending on your choice of cableinstallation.4. Be sure to use only the screws provided.5. Do not over tighten the screws, as it may result in damage tothe mounting plate.2. INSTALLING THE REMOTE CONTROLLER UNIT TO THE WALLScrewdriverScrew 3orScrew 41. Embed an outlet box into the wall. Outlet box may be purchased separately. Medium-sized square outlet box(obtain locally) Part No. DS3744 (Panasonic Corporation) or equivalent.2. Secure the remote controller mounting plate to the outlet box with the two accessory screws 3 .Make sure that the mounting plate is flat against the wall at this time, with no bending.3. Pass the remote controller cable 2 into the box.4. Route the remote controller cable 2 inside the mounting plate through rear feeding-out direction.5. Insert fi rmly the connector of remote controller cable 2 to connector (CON1) in the upper case circuit board.[Refer to the illustration at below.]6. Secure the remote controller upper case to the mounting plate with the tabs provided.WallUpper caseMounting plateUpper tabConnector (CON1)Screw 3Lower tabOutlet boxA. IF REMOTE CONTROLLER CABLE IS EMBEDDED• Allow suffi cient space around the remote controller 1 as shown in the illustration above.• Install in a place which is away from direct sunlight and high humidity.• Install on a flat surface to avoid warping of the remote controller. If installed to a wall with an uneven surface,damage to the LCD case or operation problems may result.• Install in a place where the LCD can be easily seen for operation. (Standard height from the floor is 3.9ft to 4.9ft(1.2 to 1.5 meters.))• Avoid installing the remote controller cable near refrigerant pipes or drain pipes, otherwise it will cause electricalshock or fire.1. SELECTING THE INSTALLATION LOCATIONRemotecontrollercable 2Rear feeding-outpositionMounting plateConnector(CON1)Upper caseTabsUpper caseMounting plateRemotecontrollermountingplate1 3/16"( 30mm)or more1 3/16"( 30mm)or more1 3/16"( 30mm)or more4 23/32"(120mm)or moreUpper caseMounting plateRemote controller 1Mounting plateRemotecontrollercable 2CAUTIONWhen the wall is hollow, please be sure to usethe sleeve for remote controller cable to preventdangers caused by mice biting the cable.

/ 3

Related manuals for Panasonic ACXF60-03410