Panasonic 5000 Series Operating Instructions Manual

Contents

MANAGER PROGRAMS Messages & Prompts ProgramProgram 30: Messages & Prompts ProgramProgram 30 gives you access to two types of messages: Preamble/Logo & Postamble andthe Prompts & Error Messages. Refer to the description for the type of message you wantto modify.Programming the Preamble or PostambleThe preamble is a three-line message that appears at the top of your reports andcustomer receipts. The postamble is the trailer message that prints at the bottom of thereceipts and reports. Use the following procedure to program these messages.1. With the keylock in MGR position, use this sequence to advance to the Messagesprogram.5 CASH 3 0 CASH2. Go to the address that corresponds to the line you are programming. A generaldescription for each of the addresses is provided below.[ address # ] CSHRPostamble Line Addresses Preamble Line AddressesLine 1 = 200, 201 Line 1 = 206, 207Line 2 = 202, 203 Line 2 = 208, 209Line 3 = 204, 205 Line 3 = 210, 2113. Place the alpha overlay on the keyboard and enter the new logo or postamblemessage.[ 1-16 character description ]RCPTSTOP CASH5-36 Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0