Pallmann King Cobra Operating Instructions Manual

Also see for KING COBRA: Operating instructions

Pallmann King Cobra Operating Instructions Manual Manual pdf 8 page image

Pallmann King Cobra Manual 85.0 Assembly of the machine5.1 Installing the dust tubeNote: The King Cobra is delivered with the dust tube (1) removed.Caution!Injury to the operator or other persons could occur or damage could occur if themachine starts up unintentionally. Disconnect the machine from the power supplybefore working on the machine!fatalInstructions:1. Insert the dust tube (1) into the dust tube support (7). The curved section ofthe tube must face toward the motor. Clamp the dust tube by means of theclamping lever (6) located on the guide tube support.2. Fit the connector (8) into both screws of the pull rod.3. Move the main lifting lever (2) into the rear position to raise the sanding drumfrom the floor.4. Tighten both wing nuts.5. Install emergency stop switch to side of dust tube, and attach to motor.5.2 Installing the motorInstallation of the motor is performed in the opposite order to the steps describedin Chapter 6.2 removing the motor.Contents1 Introduction ..................................................................................................................................................................... 42 Scope of delivery ............................................................................................................................................................ 53 Machine specifications COBRA CLASSIC ................................................................................................................... 63.1 Important components ...................................................................................................................................................... 63.2 Technical data .................................................................................................................................................................. 73.3 Safety and machine protection facilities............................................................................................................................ 74 Proper use ....................................................................................................................................................................... 75 Assembly of the machine............................................................................................................................................... 85.1 Installing the guide tube ................................................................................................................................................... 85.2 Installing the motor ........................................................................................................................................................... 86 Disassembling for transport ......................................................................................................................................... 96.1 Removing the guide tube ................................................................................................................................................ 96.2 Removing the motor.......................................................................................................................................................... 107 Operating the COBRA CLASSIC .................................................................................................................................. 117.1 Protective clothing and equipment .................................................................................................................................. 117.2 Fitting the dust bag ........................................................................................................................................................ 117.3 Safety instructions regarding dust .................................................................................................................................... 127.4 Disposing of sanding dust ............................................................................................................................................... 127.5 Replacing the sanding belt .............................................................................................................................................. 137.6 Adjusting the sanding pressure ....................................................................................................................................... 147.7 Safety instructions for electric cable and connectors ...................................................................................................... 147.8 Connecting the COBRA CLASSIC to the mains power .................................................................................................. 157.9 Remarks about sanding parquet and plank floors .......................................................................................................... 167.10 Sanding with the COBRA CLASSIC ............................................................................................................................... 198 Maintenance ................................................................................................................................................................... 248.1 Changing the sanding drum ............................................................................................................................................ 248.2 Adjusting the running wheels .......................................................................................................................................... 268.3 Adjusting the castor wheels ............................................................................................................................................ 278.4 Adjusting the tension roller ............................................................................................................................................... 288.5 Changing the belt.............................................................................................................................................................. 298.6 Checking dust extraction ................................................................................................................................................. 308.7 Switching off and storing the machine ............................................................................................................................ 309 Declaration of conformity .............................................................................................................................................. 3110 Warranty........................................................................................................................................................................... 32