Pallmann King Cobra Operating Instructions Manual

Also see for KING COBRA: Operating instructions

Pallmann King Cobra Operating Instructions Manual Manual pdf 20 page image

Pallmann King Cobra Manual 208 Maintenance8.1 Changing the sanding drumIf the sanding drum is damaged or worn, it must be replaced.Instructions:1. Turn the machine off.2. Disconnect the machine from the mains power.3. Open the sanding drum cover (1).4. Fold the tension lever (2) forward to relieve the tension on the sanding belt.5. Remove the sanding belt (3) to the side.6. Unscrew the retaining nut (4):The retaining nut is glued to the threads of the sanding drum shaft to ensure that itfall off while the COBRA is in operation. To unscrew the retaining nut, use the doublwrench that comes with the machine. Lower the sanding drum so it has contact with8.0 Maintenance8.1 Changing the sanding drumIf the sanding drum is damaged or worn, it must be replaced.Instructions:1. Turn the machine off.2. Disconnect the main power from motor.3. Open the sanding drum cover (1).4. Fold the tension lever (2) forward to relieve the tension on the sanding belt.5. Remove the sanding belt (3) to the side.6. Unscrew the retaining nut (4):The retaining nut is glued to the threads of the sanding drum shaft to ensure that itwill not fall off while the King Cobra is in operation. To unscrew the retaining nut, usethe double fork wrench that comes with the machine. Lower the sanding drum soit has contact with the floor to prevent it from turning while you are unscrewing theretaining nut.Contents1 Introduction ..................................................................................................................................................................... 42 Scope of delivery ............................................................................................................................................................ 53 Machine specifications COBRA CLASSIC ................................................................................................................... 63.1 Important components ...................................................................................................................................................... 63.2 Technical data .................................................................................................................................................................. 73.3 Safety and machine protection facilities............................................................................................................................ 74 Proper use ....................................................................................................................................................................... 75 Assembly of the machine............................................................................................................................................... 85.1 Installing the guide tube ................................................................................................................................................... 85.2 Installing the motor ........................................................................................................................................................... 86 Disassembling for transport ......................................................................................................................................... 96.1 Removing the guide tube ................................................................................................................................................ 96.2 Removing the motor.......................................................................................................................................................... 107 Operating the COBRA CLASSIC .................................................................................................................................. 117.1 Protective clothing and equipment .................................................................................................................................. 117.2 Fitting the dust bag ........................................................................................................................................................ 117.3 Safety instructions regarding dust .................................................................................................................................... 127.4 Disposing of sanding dust ............................................................................................................................................... 127.5 Replacing the sanding belt .............................................................................................................................................. 137.6 Adjusting the sanding pressure ....................................................................................................................................... 147.7 Safety instructions for electric cable and connectors ...................................................................................................... 147.8 Connecting the COBRA CLASSIC to the mains power .................................................................................................. 157.9 Remarks about sanding parquet and plank floors .......................................................................................................... 167.10 Sanding with the COBRA CLASSIC ............................................................................................................................... 198 Maintenance ................................................................................................................................................................... 248.1 Changing the sanding drum ............................................................................................................................................ 248.2 Adjusting the running wheels .......................................................................................................................................... 268.3 Adjusting the castor wheels ............................................................................................................................................ 278.4 Adjusting the tension roller ............................................................................................................................................... 288.5 Changing the belt.............................................................................................................................................................. 298.6 Checking dust extraction ................................................................................................................................................. 308.7 Switching off and storing the machine ............................................................................................................................ 309 Declaration of conformity .............................................................................................................................................. 3110 Warranty........................................................................................................................................................................... 32