PAC RadioPRO4 Manual

Also see for RadioPRO4: Manual

PAC RadioPRO4 Manual Manual pdf 1 page image

RP4-FD11Radio Replacement & Steering Wheel Control Interfacefor Ford/Lincoln/Mercury VehiclesPacific Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com©2011 Pacific Accessory Corporationwww.pac-audio.comRev. 112811Pacific Accessory CorporationIntroduction & FeaturesImportant NotesWiring Connection ChartThe RP4-FD11 interface allows the replacement of a factory radio in select Ford/Lincoln/Mercury vehicles with MSCANdatabus radios. Using this interface will retain factory features such as steering wheel controls (SWC), rear seatentertainment (RSE), Rear Seat Controls (RSC) and the THX or Sony amplifier when the original radio is removed. TheRP4-FD11 also provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS),illumination, reverse trigger and parking brake.1.The radio select rotary switch on the side of the interface must be adjusted to the proper radio settingbefore plugging the interface into the vehicle (see below for setting chart).2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unlessyou wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressingand releasing the program button on the side of the interface once and waiting 7 seconds for the LED to flash 4 times.3. RSC & LCD buttons that are identical to the SWC will mimic the SWC one for one. All other buttons cannot be programmed.4. The LED will flash whenever a SWC button is pressed.5. The RSC must be in AM mode for Track +/- to function. RSC must be set to AUX mode to pass audio to aftermarket radio.6. Vehicles equipped with a factory amplified system must disconnect SYNC if they wish to use the voice button. Not disconnectingSYNC will result in the rear speakers muting every time the voice button is pressed.7. Feeding too strong of an audio signal into the headrest monitors will cause the audio output to shut down. If this happens youmust turn the tv off and on and lower the audio signal.Red / White P.B. Output (-)Purple / White VSS OutputBlue / White Amp Turn On InputRed Acc. Output (1 amp)Orange / White Illum. Output (+)Green Reverse Output (+)Interface ConnectorYellow Battery +12vBlack GroundBlue Antenna On InputWhite Front L + inputWhite / Black Front L - inputGrey Front R + inputGrey / Black Front R - inputGreen Rear L + inputGreen / Black Rear L - inputPurple Rear R + inputPurple / Black Rear R - inputVehicle Connector SWC ConnectorBlu/Yel Kenwwod, NewerJVC, OEM orBlaupunkt3.5mm Jack Alpine, JVC,Clarion, Pioneer,Sony, Valor, Boyo,Dual, Visteon orAdventPage 1

/ 5

Related manuals for PAC RadioPRO4