PAC C2R-CHY4 Installation Instructions Manual

Also see for C2R-CHY4: Installation guide User manual

PAC C2R-CHY4 Installation Instructions Manual Manual pdf 1 page image

Radio ConnectionChart(Read the Installation Notes before makingconnections to the provided radio harness)Yellow Battery +12vBlack GroundBlue Antenna On InputWhite Front L + inputWhite I Black Front L - inputGrey Front R + inputGrey I Black Front R - inputGreen Rear L + inputGreen I Black Rear L - inputPurple Rear R + inputPurple I Black Rear R - inputCAN Interface Connection Chart:Red Ace. Output(1amp)Red I WhiteP.B.Output(-)Purple I White VSS Output (Pulse)Orange I White Ilium. Output(+)Green Reverse Output (+)White I GreenC2R-CHY4Radio Replacement Interfacewith Nav Outputs for all ChryslerDodge I Jeep CANbus Vehicles WithorWithout Premium Audio SystemsNavigationoutputsandAmplifier Remote InputSeeChart forwirecolordescriptions.~r:=;~~~---Jr-......__-1~~"Radio Specific Steering~8'Wheel ControlInterface••cl'•(Sold Separately)- 'ProgramSWC;Interface forVersion 2.\.Installation Notes1.Only one of the two provided radio harnesses will be used. Remove the factoryinstalled radio to determine the correct harness for your particular vehicle.2.Vehicleswithoutafactoryamplifier: Connect the aftermarket radio's front andrear speaker wires to the 22 pin plug.SWC OutputBlue I White Amp Turn On Input3.Vehicleswitha factory amplifier: The factory amplifier only accepts two audiochannels (left and right). The amplifier's fading is controlled by data communicationfrom the factory radio. The aftermarket radio does not have the ability to control theamplifier's fader. Connect thefrontoutputsofthe aftermarket radio to the rear inputsofthe 22pinradio connector. This willallow navigation voice prompts and Bluetooth calls to be heard. The rear speaker outputs of the aftermarket radio are not used.4. The accessory output wire is located on the11pin CAN INTERFACE harness -connect this wire to the radio's accessory wire. Theaccessory wire supplies +12v, 1 amp max when key is in the accessory or ignition position (fig. 1: If more current is needed).5.11pin plug (to CAN INTERFACE):1.Blue/White - Connect this wire to the radio's amplifier remote output. Connect this wire with or without OEM amp present!2. White/Green - SWC output.3. Green - Connect this wire to the radio's reverse input wire only.4. Orange/White - Connect this wire to the radio's Illumination input wire only.5.Violet/White- Connect this wire to the radio's VSS input wire only.6. Red/White - Connect this wire to the radio's parking brake input wire only.Note: Do not connect these wirestoany circuit other than the radio's wire harness.6.11pin plug (to SWC INTERFACE):This is a quick connection to a radio specific SWC interface. No additionalconnections are necessary other than radio control connections. Plug the radiospecific SWC interface in to this connector and program the radio specific SWCinterface for version 2. Do not cut the loops. Refer to the SWC interface instructionmanual for the radio specific control function programming order.Fig. 1(using a SPDT re lay)12v Ace.or equivelantHigh Current 12v(Fused)Ground7. Refer to the aftermarket radio's instruction manual for testing VSS, Reverse, Parking Brake and Illumination outputs. For the mostcurrent and Up-to-Date application guide please visit www.pac-audio.com7-19-10 Pacific Accessory Corporation- Ontario California, 91761techsupport@pac-audio.com • www.pac-audio.com

/ 5

Related manuals for PAC C2R-CHY4