OneStart

Menu

Octel Aria 1.2 Release Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Page 39 preview
Page 40 preview
Page 41 preview
Page 42 preview
Page 43 preview
Page 44 preview
Page 45 preview
Page 46 preview
Page 47 preview
Page 48 preview
Page 49 preview
Page 50 preview
Page 51 preview
Page 52 preview
Page 53 preview
Page 54 preview
Page 55 preview
Page 56 preview
Page 57 preview
Page 58 preview
Page 59 preview
Page 60 preview
Page 61 preview
Page 62 preview
Page 63 preview
Page 64 preview
Contents
  1. Edition
  2. Table Of Contents
  3. Table Of Contents
  4. Table Of Contents
  5. Table Of Contents
  6. Features for Service Personnel
  7. Features Administered by System Managers
  8. Compatibilities With Applications
  9. Multiline Networking
  10. ASCII Name Verification
  11. Control of MWI
  12. TDD/TTY Support
  13. Application Easy Access
  14. Node Expansion
  15. Overview
  16. Check The Major Steps
  17. Make Sure that the Correct Equipment is Available
  18. Software
  19. Verify the System Boot Area
  20. Connect the PC and the Server
  21. PC-to-Octel Overture 350 Direct Connection
  22. Connecting the PC remotely to the server
  23. Install the Online Upgrade Tool on the PC Hard Drive
  24. PC's ONLINE UPGRADE Installation Program Screen
  25. Verify the Values in the PC Setup Menu
  26. Load Software and Phrase Diskettes on the PC Hard Drive
  27. Copy/Delete UPG Menu
  28. Verification Prompt
  29. Status Messages Screen With File Copy Complete Message
  30. Perform the Automatic Upgrade
  31. Modem Setup Menu
  32. Example of Status Messages Box With Confirmation Prompt
  33. Verify the Upgrade
  34. Reset the Boot Area, and Boot the New Software
  35. Make Software and Phrase Areas Redundant
  37. FLT-A Card and its Removal and Replacement
  38. Example of Menu 13.11, Review Card Management
  39. Conversion of Branch, Aspen, or Maxum to Octel Overture 250 Using PC Tape
  40. Menu 20.1.5, Port Traffic Statistics Utility
  41. Mixed 1-GB, 2-GB, and 4-GB Message Drives, and the Upgrade Message Drive Utility
  42. Reset Mirrored Drive Status Utility
  43. Collapse Nodes Utility
  44. Example of the Node Collapsing Utility Screen
  45. Revised Enable Drive Utility
  46. Hot-Plug Replacement of Tape Drive in Octel Overture 250
  47. Hot-Plug Addition of a Second System Drive in Octel Overture 250
  48. Flash EPROMs on CCF Card
  49. New Error Messages for Tape Drive Operations
  50. PCR CORRECTIONS
Octel Aria 1.2 Release Manual Manual pdf 30 page image
Online Upgrade Instructions 2-13101–1477–001 Edition 2Octel Communications CorporationONLINE UPGRADEInstallation Programv. 1.3About to install ONLINE UPGRADE to your HARD DRIVESource drive: a:Target drive: c:Press CTRL–C if this information is NOT correctPress any key to continue . . .Figure 2-5. PC’s ONLINE UPGRADE Installation Program Screen.7. Press any key. The names of the upgrade files are displayed on the screen as they are copiedonto the PC hard drive. When the upgrade tool installation is complete, the screen shown inFigure 2-6 appears.End of ONLINE UPGRADE InstallationAbout to run PCUPGRDPress any key to continue . . .Figure 2-6. Screen Showing End of ONLINEUPGRADE Installation.8. Press any key. Remove the diskette, as instructed.9. If the PC has Windows 3.x installed, at the C:\PCUPG> prompt, type pcupgrd and pressEnter to run the upgrade procedure from the hard drive. The Online Upgrade Main Menuscreen appears, as shown in Figure 2-7. Skip to the next section of this procedure.10. If you are using the PC’s COM 2 port and if and only if the PC has Windows 95 installed,special utilities described in Product Alert 92 must be installed. Call the Octel TechnicalAssistance Center (TAC) to obtain the diskette that has these utilities; follow the installationinstructions provided with the diskette. Installing these utilities establishes two new icons onthe desktop. After you install the utilities, close any open applications, double-click on thenew icon named Pcupgrdw, and click on Yes to restart the PC in MS-DOS mode and launchthe online upgrade tool. The Online Upgrade Main Menu screen appears, as shown inFigure 2-7.Do not install the utilities from TAC if the PC has Windows 3.x installed.
/ 64
This manual is suitable for:
Aria 1.2
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved