PR Series Balance EN-4111. COMPLIANCECompliance to the following standards is indicated by the corresponding mark on the product.Mark StandardThis product complies with the EU Directives 2011/65/EU (RoHS), 2014/30/EU (EMC), 2014/35/EU(LVD) and 2014/31/EU (NAWI). The EU Declaration of Conformity is available online atwww.ohaus.com/ce.EN 61326-1, AS/NZS 61010-1CAN/CSA-C22.2 No. 61010-1UL Std. No. 61010-1This product complies with the EU Directive 2012/19/EU (WEEE). Please dispose of this product inaccordance with local regulations at the collecting point specified for electrical and electronicequipment.For disposal instructions in Europe, refer to www.ohaus.com/weee.Important notice for verified weighing instruments in the EUWhen the instrument is used in trade or a legally controlled application it must be set up, verified and sealed inaccordance with local weights and measures regulations. It is the responsibility of the purchaser to ensure that allpertinent legal requirements are met.Weighing Instruments verified at the place of manufacture bear the following supplementary metrology marking onthe descriptive plate.Weighing Instruments to be verified in two stages have no supplementary metrology marking on the descriptiveplate. The second stage of conformity assessment must be carried out by the applicable weights and measuresauthorities.If national regulations limit the validity period of the verification, the user of the weighing instrument must strictlyobserve the re-verification period and inform the weights and measures authorities.As verification requirements vary by jurisdiction, the purchaser should contact their local weights and measuresoffice if they are not familiar with the requirements.FCC NoteThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferencewhen the equipment is operated in a commercial environment. This equipment generates, uses, and can radiateradio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of this equipment in a residential area is likely to cause harmfulinterference in which case the user will be required to correct the interference at his own expense.Industry Canada NoteThis Class A digital apparatus complies with Canadian ICES-003.ISO 9001 RegistrationIn 1994, OHAUS Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau VeritasQuality International (BVQI), confirming that the OHAUS quality management system is compliant with the ISO9001 standard’s requirements. On June 21, 2012, OHAUS Corporation, USA, was re-registered to the ISO9001:2008 standard.