Novatel OEM719 Installation And Operation Manual

Also see for OEM719: Installation and operation manual Guide

Contents

Novatel OEM719 Installation And Operation Manual Manual pdf 92 page image

Chapter 5 Ethernet ConfigurationOEM7 Installation and Operation User Manual v4 92Figure 35: Cross-Over Ethernet Cable Configuration—OEM7 Receiver5.2.1 Static IP Address Configuration—ReceiverFollow these steps to set up a static IP address on the OEM7 receiver:1. Connect a computer to the OEM7 receiver using a null modem serial cable or USB cable.2. Establish a connection to the receiver using either NovAtel Connect or another terminal pro-gram. This connection is used to send the commands in this procedure to the receiver.For information about establishing a connection using NovAtel Connect, refer tothe Help within NovAtel Connect.NovAtel Connect version 2.0 or greater is required for OEM7 receivers.Download the latest NovAtel Connect software and documentation fromwww.novatel.com/novatel-connect.3. Enable the Ethernet port on the receiver by entering:ETHCONFIG ETHA AUTO AUTO AUTO AUTO4. Assign the TCP/IP port number used for the connection by entering:ICOMCONFIG ICOM1 TCP :20005. Assign the receiver IP address, subnet mask and default gateway by entering:IPCONFIG ETHA STATIC 192.168.74.10 255.255.255.0 192.168.74.1