Norton CTC701 Owner's Manual

Contents

Norton CTC701 Owner's Manual Manual pdf 15 page image

15the table to align the guide. Then tighten it back.5.3 General Advice For Cutting• Only tiles with max. dimensions of 15-3/4”x15-3/4”x1/4” (400x400x6mm) andmax. weight of 6-1/2 lbs (3kg) can be cut with the machine.• Before beginning work make sure tools are firmly seated!• Select the right Norton Diamond Blade as recommended by Norton Clipper whichdepends on the material to be cut, and if cutting wet or dry.• Make sure the water tray contains enough water.• Set the guide-a-cut to the desired width of cut, using the two engravedmeasurements to align it correctly.• Do not force on the motor. This machine is not designed for a continuous use.6. Maintenance And ServicingTo ensure a long-term quality from the cutting with the CTC701, please follow themaintenance plan below:6.1 Maintenance Of The MachineAlways perform the maintenance of the machine with the machine isolated from theelectrical supply.6.2 LubricationThe CTC701 uses life-lubricated bearings. Therefore, you don’t need to lubricate themachine at all.