NorthStar GM1708 961X Installation Manual

Also see for 961X: Reference manual Operation and reference manual

NorthStar GM1708 961X Installation Manual Manual pdf 57 page image

SECTION THREE - Interfacing961 INSTALLATION MANUAL Revision A Page 47Figure 24: Port 1 output setup screenCheck the installation instructions of the equipment to which you’reinterfacing for any special requirements. The Northstar factory settingswill be adequate for most peripheral equipment, but the following optionsare available, if needed:Table 6: Port setup optionsParameter OptionsOUTPUT FORMAT(see below)choose OFF, 0180, 0183,0183-R, or CDXNMEA 0183 Talker ID(see page 51)choose GP or II to make the unitlook like a GPS receiver or an“integrated instrument” (II)NMEA 0183 lat/lon precision(see page 52)choose hundredths of minutes,thousandths of minutes, orten-thousandths of minutesOUTPUT RATE(see page 53)choose 1 to 199 secondsNMEA 0183 waypoint ID as(see page 53)choose NAMES or NUMBERSfor the identifier of waypointssent to the external deviceNMEA 0183 checksums(see page 53)choose ON or OFF for compati-bility with some older devicesNMEA 0183 baud rate The baud rate is fixed at 4800