Napoleon NCPF-110 Installation And Operating Instructions Manual

Napoleon NCPF-110 Installation And Operating Instructions Manual Manual pdf 24 page image

24W415-0771 / B / 08.10.093. Put about 3-4 cups of pellet at the bottom of fire pot manually. It is always easier to start the fire with pellet.4. Add some fire gel to the pellets and mix it. You may also use solid type fire starters.5. Make sure that control panel is at off position.6. Use a match to start the fire. You may keep the door open for a while, just to observe fire going.7. Let the fire continue by itself for a minute or two.8. Select corn as your fuel on the control panel when off.9. Turn on the control panel by pushing the on button for few seconds.10. Press the first fire button. Furnace will count down 500 seconds on this mode. Combustion air fan ison to facilitate the first fire start-up. There will also be automatic corn feeding of 2 seconds at 200thsecond.OCCURRENCE OF EXCESSIVE SMOKE DURING THE FIRST FIRE MODE IS NORMAL. THIS IS A TEM-PORARY CONDITION AND IT WILL BE OVER IN A FEW MINUTES. PLEASE DO NOT PANIC.11. Furnace will automatically go into low mode at the end of 500 seconds, if no other mode selection ismade.12. You may close the door anytime now when you feel fire is strong and will keep going.13. You may also choose to run your furnace at high mode depending on your heating requirements andcomfort level. You do not have to wait till end of first fire mode to select your furnace run mode.14. It will take about 15-20 minutes for the fire to stabilize and reach temperature. We do not recommendstirring the content of fire pot after the first fire.15. Now, just sit back and enjoy the heat.16. If room thermostat is connected you don’t have to choose any mode. Room thermostat will take over thecontrol of furnace.6.7 FIRST FIRE (START UP) - WOOD PELLET BURNINGAssuming you have completed the installation of the furnace, connection of hot air outlet & return air to ductsystem, you can now put your furnace into operation.Please follow the instructions below, step by step.1. Fill the hopper with wood pellets. (Will take about 400 lbs –-- 10 x 40 lbs bags))2. Please keep in mind that auger is empty on the very first operation. Use the manual fuel feed button on theback of the control box to fill the auger fast.3. Put about 3-4 cups of pellet at the bottom of fire pot.4. The rest of the operation is same as “corn burning” starting with #4.Use of mix fuel:Corn & pellet mix use is permissible. Mixing corn with pellet will improve combustion of corn. Fuel selection onthe control panel may remain at “corn” when higher percentage of fuel is corn.6.8 OPERATION BY ROOM THERMOSTATRoom thermostat takes over control of furnace when connected. Room thermostat will run the furnace at themode needed, depending on your room temperature settings. (Please note that mode display on the controlpanel has no meaning when running by thermostat).I M P O R T A N T N O T EDepending on the preference for your location, room thermostats may be two different types.1. Open contact type,2. Close contact type.When control panel is turned on, display will indicate the current setting for “room thermostat” on your furnace.Factory setting is for open contact type. Please see your installation manual regarding how to change the set-ting.